Abstract:Abstract When the fine-blanking process is used, secondary grinding or processing can be omitted because the shear surface of fine-blanking parts can achieve almost zero fracture zone requirements. The primary objective of the fine-blanking process is to reduce the fracture zone depth and die roll zone width. This study used a 2.5-mm-thick central processing unit (CPU) thermal heat spreader as an example. Finite element analysis software was employed to simulate and optimize the main eight process parameters that affect the fracture zone depth and die roll zone width after fine-blanking: the V-ring shape angle, V-ring height of the blank holder, V-ring height of the cavity, V-ring position, blank holder force, counter punch force, die clearance, and blanking velocity. Simulation analysis was conducted using the L 18 (2 1 × 3 7 ) Taguchi orthogonal array experimental combination. The simulation results of the fracture zone depth and die roll zone width were optimized and analyzed as quality objectives using Taguchi’s smaller-the-better design. The analysis results revealed that with fracture zone depth as the quality objective, 0.164 mm was the optimal value, and counter punch force made the largest contribution of 25.89%. In addition, with die roll zone width as the quality objective, the optimal value was 1.274 mm, and V-ring height of the cavity made the largest contribution of 29.45%. Subsequently, this study selected fracture zone depth and die roll zone width as multicriteria quality objectives and used the robust multicriteria optimal approach and Pareto-optimal solutions to perform multicriteria optimization analysis. The results met the industry’s fraction zone depth standard (below 12% of blank thickness) and achieved a smaller die roll zone width.

Improvement of Die-Roll Quality in Compound Fine-Blanking Forming Process

An Investigation of Step-Shaped-punch Fine-Blanking Process Using Finite Element Method

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Improvement of product quality using negative clearance grooved punch

Finite element simulation of the effect of clearance on the forming quality in the blanking process

Numerical simulation and optimization of process parameters in fineblanking process

Finite element optimization of veering factor in fine-blanking process

Improving the Quality of Hot Stamping Parts with Innovative Press Technology and Inline Process Control

Advances in Forming Simulation for Fine-Blanking Process

State-of-the-art and Future Challenge in Fine-Blanking Technology

A New Approach of Die Shape Optimization for Sheet Metal Forming Processes

Reduction of Die Roll Height in Duplex Gears Through a Sheet-Bulk Metal Forming Method

Improvement of Hydro-Mechanical Drawing Die and Process

The Composite Die Design of Bending Flanging

A Study of Fine Blanking Process by Fem Simulation

Composite Die Design of Deep Drawing Flanging Trimming and Punching Bottom Hole

Numerical simulation and optimization of fine-blanking process for copper alloy sheet

Failure and forming quality study of metallic foil blanking with different punch-die clearances

Numerical simulation of fine-blanking process using a mixed finite element method

Die Design for Cylinder-shaped and Thin-walled Part

Accurate die design for automotive panel stamping considering the compensation related with die deflection and blank thinning