Transition of probability of sand grain creep at the initial stage of aeolian transport

ZHAO Xiao-hu,LI Zhen-shan
DOI: https://doi.org/10.13826/j.cnki.cn65-1103/x.2008.03.007
2008-01-01
Arid Land Geography
Abstract:The transition probability of creep sand grain is important for confirming the ratio of creep flux. Mathematical models are developed for movement modes of sand grains transiting from rolling to rest and saltation by means of two random variables(wind velocity near the bed surface and the position of sand grains in the bed). And the terminal probabilities of three modes of movement are deducted as well by the limit as time approaches infinity. A relative creeping probability which manifests the ratio of the creeping one in total flux are numerated with the total probability of creeping and saltation being divided by the probability of creeping. It turns out to be that the three probabilities are the function of time, grain diameter and the profile of wind velocity on the surface of sand bed. The rest probability decreases when the rolling time increases and the grain diameter decreases. The rolling probability increase first and then decrease when the rolling time increases under a certain grain diameter; but over a certain grain diameter, the rolling probability will increase monotonously. The saltation probability increases when the rolling time increases. The time reaching steady state increases when the grain size increases. The three probabilities of the same grains will limit to a fixed value under certain wind profile. The terminal probability and relative creep probability are not a constant but have a wide range. The terminal probability of rest and saltaion increases and decreases respectively when the grain size increases and that the terminal probability of creep first increases and then decreases. The relative probability of creep which can be interpreted as the relative amount of creep sand in all motional sand changes little with the average and variance of the wind. Grain diameter is the most important factor influencing the relative creep probability. The conclusion is corresponding with past experimental results considering the ratio of relative creep flux as a constant (25%) when the grain size is 0.25mm.
What problem does this paper attempt to address?