Investigation of several influential factors on flow cytometry analysis of CD55 and CD59 expression on red blood cells

Weiwei ZHANG,Jun ZHANG,Chaoping FANG,Qian SHEN
DOI: https://doi.org/10.3969/j.issn.1673-8640.2011.09.011
IF: 1.865
2011-01-01
Laboratory Medicine
Abstract:Objective To study some factors that may influence the measurements of CD55 and CD59 expression on red blood cells by flow cytometry and establish the standard operation procedure.Methods Ethylene diamine tetraacetic acid(EDTA)-anticoagulated peripheral bloods from 15 patients with non-hematological disorder and 11 patients with paroxysmal nocturnal hemoglobinuria(PNH) were determined for CD55 and CD59 expression on red blood cells by flow cytometry.The various amounts of monoclonal antibody(mAb),the fluorescein type that conjugated with mAb and the staining time were analyzed.Results The mean fluorescence intensity(MFI) increased with the increasing amount of mAb before the saturated amount of mAb(<9 μL) were added.The positive rates and MFI from using anti-CD55 labeled with fluorescein isothiocyanate(FITC) were lower than those from anti-CD55-phycoerythrin(PE).There was no statistical significance in CD59 positive rate between FITC and PE,while the higher MFI was observed significantly using anti-CD59-FITC.The staining time had a significant impact on not only the positive rate of CD55-PE but also the MFI obtained from CD59-FITC and CD55-PE(P<0.05),except the CD59-FITC positive rate between the 2 groups with 3 h.Conclusions The flow cytometry analysis of CD55 and CD59 expression on red blood cells is strongly influenced by the mAb amount,the mAb′s fluorescein type and staining time.To ensure a proper reaction and a reliable result,we recommend a two-color staining method of anti-CD59-FITC and anti-CD55-PE,red blood cells in the range from 1.6×105 to 2.8×105 stained with 12 μL of each mAb and an incubation time of 40 min.
What problem does this paper attempt to address?