Study on Adsorption Mechanism of Pb(II) and Cu(II) in Aqueous Solution Using PS-EDTA Resin

Liyuan Wang,Liuqing Yang,Yanfeng Li,Yun Zhang,Xiaojie Ma,Zhengfang Ye
DOI: https://doi.org/10.1016/j.cej.2010.08.017
IF: 15.1
2010-01-01
Chemical Engineering Journal
Abstract:Batch sorption experiments were conducted using a PS-EDTA resin as a sorbent to adsorb Cu(II) and Pb(II) ions from single component system. The results showed that both the Cu(II) and Pb(II) ions sorption capacity and efficiency reach a high level at an initial pH value of 6, the adsorption capacity of Cu(II) and Pb(II) ions were 42.1mg/g and 32.1mg/g at initial concentration of 100mg/L, and the maximum efficiency were 99.8% and 99.6% at 5mg/L, respectively. The equilibrium data for the adsorption of Cu(II) and Pb(II) on PS-EDTA resin were tested with three adsorption isotherm models which were found to be suitable for the two ions’ adsorptions. In addition, the kinetic adsorption fitted well to the pseudo-second-order model and the corresponding rate constants were obtained. Furthermore a higher desorption efficiency of Cu(II) and Pb(II) from the PS-EDTA resin using acid treatment was available. The column capacity for Cu(II) and Pb(II) adsorption for the bed height of 0.15m, hydraulic loading rate of 2.5m3/(hm2) and the feed concentration of 50mg/L and 100mg/L for 50% breakthrough concentration were found to be 49.8mg/g, 87.4mg/g and 48.7mg/g, 91.2mg/g, respectively.
What problem does this paper attempt to address?