Abstract:Impingement on blade surface by fine particles with high velocity is commonly seen in steam turbines, gas turbines and compressors, which affect the service life and reliability of the equipment. Study on particles’ rebound characteristics is of great significance to reduce the blade erosion and to control particle trajectory. Based on the nonlinear explicit dynamics analysis software ANSYS/LS-DYNA, the impacts of fine spherical particles with different diameters (20 to 500μm) on a typical martensitic stainless steel (AISI 403) target with high velocity (50 to 250m/s) have been systematically studied. The influences of incident velocities, impact angles, particles sizes on its rebound characteristics, relative impact depth, and relative dissipated energy have been analyzed. Results show that velocity restitution coefficient e decreased with the impact angle β1, the incident velocity V1, and the particle size dp. However, the role of particle size on the velocity restitution coefficient seemed to be far less than that of the other two factors. Both of particle’s tangential and normal velocity coefficient of restitution declined with the increasing impact angle in most cases. However, when the incident velocity V1 = 200m / s and the impact angle β1 > 45°, the tangential velocity restitution coefficient et of 100 μm and 200 μm particles increased with the increase in the impact angle β1. The reason might be that the relative impact depth drel was located a zone ranged from 0.1515 to 0.1677, where the tangential rebound behavior could be enhanced. Most of the variation of the tangential and normal velocity restitution coefficient along β1 decreased with the increase in the particle diameter. However, when V1 = 200m/s and β1 > 15°, the tangential reflected velocity of the larger particles was enhanced gradually. In addition, the values of the relative impact depth drel increased with the increasing impact angle and incident velocity, and it increased with the increasing particle diameter in most cases. The relative dissipated energy of particles steadily increased with the impact angle and incident velocity, respectively. Particle diameter had little effect on energy dissipation in comparison with the impact angle and incident velocity.

Experimental Investigation on Rebound Characteristics of Impinging Glass Beads on Plates

Experimental and Numerical Studies on Rebound Characteristics of Non-Spherical Particles Impacting on Stainless-Steel at High Temperature

The effect of incident angle on the rebound behavior of micro-particle impacts

Experimental and numerical investigation on the ballistic performance of aluminosilicate glass with different nosed projectiles

Collision and Rebound of Ping Pong Balls on A Rigid Target

Experimental Study of a Drop Bouncing on a Liquid Surface

Impact Crushing and Rebound of Thin-Walled Hollow Spheres

Dissipative properties for a ball bouncing on a vertically vibrating plate

The Behaviors of Particle-Wall Collision for Non-Spherical Particles: Experimental Investigation

Measurement of Restitution and Friction Coefficients for Granular Particles and Discrete Element Simulation for the Tests of Glass Beads

Effect of stress-state adjustment on fragmentation behavior of quartz glass beads subjected to low-velocity impact

Experimental analysis of lateral impact on planar brittle material

Experimental study of particle collision and rebound with moving walls

Numerical simulations of the normal impact of adhesive microparticles with a rigid substrate

Experimental Investigation of Interparticle Collision in the Upper Dilute Zone of a Cold CFB Riser

A Study on the Impact Properties of Typical Glassy Materials

The collision behaviors of non-spherical regular particle-wall in three-dimensional space: Experimental investigation

EXPERIMENTAL INVESTIGATION OF INTER-PARTICLE COLLISION RATE

Exploring the Regimes of Particle Behavior upon Impact via the Discrete Element Method

Study on Rebound Characteristics of Fine Spherical Particles Impacting an Aisi 403 Steel with High Velocity

Experimental Study on the Rebound Characteristics of Oblique Collision of Ash Particles and the Influence of Ammonium Bisulfate