Abstract:Ash aerosol and ash deposit formation during oxy-coal combustion were explored through experiments in a self-sustained 100kW rated down-fired oxy-fuel combustor. Inlet oxidant conditions consisted of 50% inlet oxygen with CO2 (hereafter denoted as OXY50 conditions). A Berner low pressure impactor (BLPI), a scanning mobility particle sizer (SMPS), and an aerodynamic particle sizer (APS) were used to obtain size segregated ash aerosol samples and to determine the particle size distributions (PSD). A novel surface temperature controlled ash deposition probe system that allowed inside and outside deposits to be separated was used to collect the ash deposits. The ash aerosol PSDs given by the BLPI and those produced by SMPS/APS were consistent with each other. Data suggested that oxy-coal combustion under these conditions did not change the formation mechanisms controlling the bulk ash aerosol composition, but it did increase the formation of ultra-fine particles initially formed through metal vaporization, due to increased vaporization of silicon at the higher combustion temperature. The smaller particles contained within the deposits had higher Si and lower Na and S concentrations under OXY50 conditions than for air combustion. Moreover, the ash aerosol composition for particle sizes less than 2.4μm was related to the composition of the inside deposits. A higher Na in the ash aerosol resulted in higher Na in inside deposits with comparable absolute Na concentrations in both those aerosol particles and those inside deposits particles. The contribution of S and Si to the inside deposits showed that S in the vaporization modes together with Si in the ultrafine vaporization mode, contributed significantly to the composition of the inside deposits. These results provided direct evidence that prediction of the chemistry of the initial deposit layer (but not of the bulk deposits) required knowledge of the size segregated chemistry of the ash aerosol.

Experimental Study on the Rebound Characteristics of Oblique Collision of Ash Particles and the Influence of Ammonium Bisulfate

The Critical Capture Velocity of Coal Ash Particles Oblique Impact on a Stainless Steel Surface

Experimental Study on the Effects of Reheat Temperatures on the Ammonium Bisulfate and Ash Blend Deposition

Study on the Formation Process of Low‐temperature Ash Deposition Induced by Ammonium Bisulfate in Pulverized Coal‐fired Boiler

Experimental Study of the Influence of Temperatures under SCR Conditions Using an On-Line Digital Image Technique

Investigation of the Deposition Characteristics of Ammonium Bisulfate and Fly Ash Blend Using an On-Line Digital Image Technique: Effect of Deposition Surface Temperature

Experimental Study on the Ash Deposit Thermal Conductivity for Ammonium Bisulfate and Fly Ash Blend with an in Situ Measurement Technology

Experimental Study on the Effects of Calcium-Based Additives to Control Ammonium Bisulfate and Ash Mixture Deposition with an On-Line Digital Image Technique

An Experimental Study on Ash Deposition Problem of Low-Low Temperature Flue Gas System

Study on the Decomposition Characteristics of Ammonium Bisulfate and Fly Ash Blend Deposition During the Heating Process

The effect of incident angle on the rebound behavior of micro-particle impacts

Experimental and Numerical Studies on Rebound Characteristics of Non-Spherical Particles Impacting on Stainless-Steel at High Temperature

Experiment and model study of rebound/adhesion characteristics of alumina droplets colliding with walls at different temperatures

Ash Aerosol Formation from Oxy-Coal Combustion and Its Relation to Ash Deposit Chemistry

Effect of Ash Particles on Heat Transfer Characteristics of Condensing Heat Exchangers

Experimental study of particle collision and rebound with moving walls

Experimental Investigation On Three Coals Ash Formation

Experimental Investigation of Ammonia and Sulfur Deposition Characteristics in Rotary Air Preheater

Experimental Study on Cohesiveness Characteristics of Raw Cement Ash at Moderate Temperature

Influence of Ash Characteristics on Ash Deposition in Coal Fired Boiler

Experimental Study on Ash Fusion Characteristics and Slagging Potential Using Simulated Biomass Ashes