Abstract:The scratch test has been used to assess the adhesion of thin hard coatings for some time now and is a useful tool for coating development or quality assurance. However, the test is influenced by a number of intrinsic and extrinsic factors which are not adhesion-related and the results of the test are usually regarded as only semi-quantitative. The stress state around a moving indenter scratching a coating/substrate system is very complex and it is difficult to determine the stresses which lead to detachment. Furthermore, the interfacial defect state responsible for failure is unknown. However, by a careful analysis of the observed failure modes in the scratch test (not all of which are related to adhesion) it is possible to identify adhesive failures and in some cases these occur in regions where the stress state is relatively simple and quantification can be attempted.Ideally engineers would like a material parameter (such as work of adhesion or interfacial toughness) which can be used in an appropriate model of the coating-substrate system stress state to determine if detachment will occur under the loading conditions experienced in service. This data is not usually available and the development of such models must be seen as a long-term goal. In modern indentation and scratch systems the work of friction (or indentation) can be directly measured and the relationship between this parameter and adhesive failure can be demonstrated in some cases. This paper reviews the main adhesion-related failure modes and the stresses responsible for them and indicates where quantification is possible illustrating this with results from hard coatings on steel, thermally grown oxide scales and optical coatings on glass. The use of empirical calibration studies, directly measured work of friction and quantification by finite element methods is discussed.

Quantitative Evaluation of Adhesion of Metallic Coatings with an Extended Microbridge Test

On the Evaluation of the Adhesion of Electroplated Ni Coatings Upon Steel Substrate with Extended Microbridge Technique

Size-dependent Interface Adhesive Energy and Interface Strength of Nanostructured Systems

Interfacial Adhesion Measurement of a Ceramic Coating on Metal Substrate

An Evaluation of the Adhesive Strength of the Interface between a Coating and Substrate

MEASUREMENT OF ADHESION PROPERTIES OF Ni2Al3 COATING WITH A MICRO SCRATCH TESTER AND AUTOMATIC SCRATCH TESTER

Evaluation Methods on Adhesion Property of Metallic Films

Quantitative Evaluation of Bonding Strength for Hard Coatings by Interfacial Fatigue Strength under Cyclic Indentation

Numerical Study on Interfacial Delamination of Thermal Barrier Coatings with Multiple Separations

Approaches to Investigate Delamination and Interfacial Toughness in Coated Systems: an Overview

Measuring Interface Fracture Resistance in Thin Hard Films

The Repeated Spherical Indentation Test: an Efficient Way to Evaluate the Adhesion of Hard Coatings

Measurement of Adhesive Bonding Strength with an EMAT in the Resonant Mode

Evaluation of the Bond Strength of Hard Coatings by the Contact Fatigue Test

Coating failure detection in scratch testing: A cross-sectional SEM/FIB microscopic study coupled with nonlinear analysis methods in a model titanium nitride/stainless steel system

Interfacial fatigue limit as measure of cyclic bonding strength of hard coatings

Adhesion strength of ductile thin film determined by cross-sectional nanoindentation

Microstructure Parameters Affecting Interfacial Adhesion of Thermal Barrier Coatings by the EB-PVD Method

An overview of the potential of quantitative coating adhesion measurement by scratch testing

Assessment of Adhesion of Electroplated Cu and Multilayered Cu Coatings by A Bidirectional Bend Test

Development of the multifunctional tester of model CM-I for coating adhesion or friction measurement (II). Test and analysis on its results