Abstract:Focusing on the bending wave characteristic of plate-shell structures, this paper derives the complex band curve of piezoelectric phononic crystal based on the equilibrium differential equation in the plane stress state using COMSOL PDE 6.2. To ascertain the computational model's accuracy, the computed complex band curve is then cross-validated against real band curves obtained through coupling simulations. Utilizing this model, this paper investigates the impact of structural and electrical parameters on the bandgap range and the attenuation coefficient in the bandgap. Results indicate that the larger surface areas of the piezoelectric sheet correspond to lower center bands in the bandgap, while increased thickness widens the attenuation coefficient range with increased peak values. Furthermore, the influence of inductance on the bandgap conforms to the variation law of the electrical LC resonance frequency, and increased resistance widens the attenuation coefficient range albeit with decreased peak values. The incorporation of negative capacitance significantly expands the low-frequency bandgap range. Visualized through vibration transfer simulations, the vibration-damping ability of the piezoelectric phononic crystal is demonstrated. Experimentally, this paper finds that two propagation modes of bending waves (symmetric and anti-symmetric) result in variable voltage amplitudes, and the average vibration of the system decreases by 4-5 dB within the range of 1710-1990 Hz. The comparison between experimental and model-generated data confirms the accuracy of the attenuation coefficient calculation model. This convergence between experimental and computational results emphasizes the validity and usefulness of the proposed model, and this paper provides theoretical support for the application of piezoelectric phononic crystals in the field of plate-shell vibration reduction.

Wave band gaps in two-dimensional piezoelectric/piezomagnetic phononic crystals

Elastic wave band gaps in magnetoelectroelastic phononic crystals

Tuning of Band Gaps for a Two-Dimensional Piezoelectric Phononic Crystal with a Rectangular Lattice

Band Gaps of Elastic Waves in Three-Dimensional Piezoelectric Phononic Crystals with Initial Stress

Effects of inclusion shapes on the band gaps in two-dimensional piezoelectric phononic crystals

Complete band gaps in two-dimensional piezoelectric phononic crystals with {1–3} connectivity family

Study on the Existence of Band Gaps for the Transverse Mode in 2D Piezoelectric Phononic Crystals from a Point View of Connectivity

Phononic crystals containing piezoelectric material

Wave Band Gaps in Three-Dimensional Periodic Piezoelectric Structures

Bandgap Calculation and Experimental Analysis of Piezoelectric Phononic Crystals Based on Partial Differential Equations

Large two-dimensional band gaps in three-component phononic crystals

Band Gap Frequencies of Piezoelectric Phononic Crystals Tuned by Axial Force

Band gaps in phononic crystals: Generation mechanisms and interaction effects

Analysis of the existence of complete band gaps in periodic binary piezoelectric phononic crystals based on connectivity

Tunable Bandgaps in Phononic Crystal Microbeams Based on Microstructure, Piezo and Temperature Effects

Magnetically Tunable Bandgaps in Phononic Crystal Nanobeams Incorporating Microstructure and Flexoelectric Effects

Band Gap Properties Of Piezoelectric/Viscous Liquid Phononic Crystals

Control of the Elastic Wave Bandgaps in Two-Dimensional Piezoelectric Periodic Structures

Study of Band Gaps of Two-Dimensional Phononic Crystals with Criss-Crossed Elliptical Holes

Generalized Thermoelastic Wave Band Gaps in Phononic Crystals Without Energy Dissipation

Interaction Between Band Gaps Of Beam Piezoelectric Phononic Crystal