Abstract:Focusing on the bending wave characteristic of plate-shell structures, this paper derives the complex band curve of piezoelectric phononic crystal based on the equilibrium differential equation in the plane stress state using COMSOL PDE 6.2. To ascertain the computational model's accuracy, the computed complex band curve is then cross-validated against real band curves obtained through coupling simulations. Utilizing this model, this paper investigates the impact of structural and electrical parameters on the bandgap range and the attenuation coefficient in the bandgap. Results indicate that the larger surface areas of the piezoelectric sheet correspond to lower center bands in the bandgap, while increased thickness widens the attenuation coefficient range with increased peak values. Furthermore, the influence of inductance on the bandgap conforms to the variation law of the electrical LC resonance frequency, and increased resistance widens the attenuation coefficient range albeit with decreased peak values. The incorporation of negative capacitance significantly expands the low-frequency bandgap range. Visualized through vibration transfer simulations, the vibration-damping ability of the piezoelectric phononic crystal is demonstrated. Experimentally, this paper finds that two propagation modes of bending waves (symmetric and anti-symmetric) result in variable voltage amplitudes, and the average vibration of the system decreases by 4-5 dB within the range of 1710-1990 Hz. The comparison between experimental and model-generated data confirms the accuracy of the attenuation coefficient calculation model. This convergence between experimental and computational results emphasizes the validity and usefulness of the proposed model, and this paper provides theoretical support for the application of piezoelectric phononic crystals in the field of plate-shell vibration reduction.

Interaction Between Band Gaps Of Beam Piezoelectric Phononic Crystal

Exact Solution to Band Structures of One-Dimensional Viscoelastic Functionally Graded Phononic Crystals

Locally Resonant Band Gaps in Flexural Vibrations of A Timoshenko Beam with Periodically Attached Multioscillators

Experimental and Theoretical Investigation of Lowering the Band Gaps of Phononic Crystal Beams Through Fluid-Solid Coupling

Defect Mode-Induced Unidirectional Flexural Wave Transmission Using Prismatic Beams with Concentrated Gradient Masses

Applying Bandgap Defect Modes to Crack Detection in Beams Using Periodic Concentrated Masses

Band gaps in phononic crystals: Generation mechanisms and interaction effects

Bandgap Calculation and Experimental Analysis of Piezoelectric Phononic Crystals Based on Partial Differential Equations

Multi-band Design for One-Dimensional Phononic Crystals

Bandgaps in phononic crystal third-order shear deformation microbeams

Bandgap Structures Of Sh-Wave In A One-Dimensional Phononic Crystal With Viscoelastic Interfaces

Low-Frequency Bandgap Characterization of a Locally Resonant Pentagonal Phononic Crystal Beam Structure

Study of Band Gaps of Two-Dimensional Phononic Crystals with Criss-Crossed Elliptical Holes

Symmetry Breaking Induces Band Gaps in Periodic Piezoelectric Plates

Complex band structure and evanescent wave propagation of composite corrugated phononic crystal beams

Thermal Tuning of the Interfacial Adhesive Layer on the Band Gaps in a One-Dimensional Phononic Crystal

Study on the vibration attenuation property of one finite and hybrid piezoelectric phononic crystal beam

Band Gap Design of Beam-Supported Phononic Crystal by Regulation and Control of Beam Bending Stiffness

Analysis of Flexural and Torsional Vibration Band Gaps in Phononic Crystal Beam

Control of the Elastic Wave Bandgaps in Two-Dimensional Piezoelectric Periodic Structures

Large One-Dimensional Band Gaps in Three-Component Phononic Crystals Plates