Abstract:The relationship between the microstructure, magnetic properties and impedance spectroscopy of Mn–Zn ferrites doped with B2O3 (up to 0.5 wt.%) has been further investigated. The ferrites were prepared by using a citrate gel processing route. A uniform microstructure with relatively small grains (9.6±0.7 μm) is observed for undoped ferrites (boron-free), which enables good magnetic properties to be achieved (initial permeability μi is 2400, power loss PL is 26.3 kW/m3 at 100 mT).The results on the samples doped with B2O3 show that the doping does not benefit the magnetic properties of these gel-derived ferrites, but it promotes grain growth significantly. Discontinuous grain growth at low doping levels (<0.2 wt.%) results in poor magnetic properties. A maximum value of the initial permeability (μi: ∼2600) and a second minimum value (37.2 kW/m3 at 100 mT) in power loss are obtained at the 0.25 wt.% B2O3 doping level when the sample has a relatively uniform microstructure with larger grain size (39.5±3.3 μm). With further increases in B2O3 doping (⩾0.5 wt.%), the increased porosity and presence of a B-rich phase result in deteriorated magnetic properties. The results of impedance measurement are closely related to the changes in the microstructure which result from these B2O3 additions. By using two models for impedance measurement analysis (The Koops’ model and the simple model), the contributions of B2O3 to grain boundary resistivity and bulk resistivity can be separated. It is shown that, whilst B2O3 has previously been considered to act as only a grain boundary additive, the impedance analysis indicates that both boundary resistivity and grain (bulk) resistivity are increased, thus implying the possible solution of some B2O3 within the ferrite spinel structure or an effective change in composition of grain as result of presence of B2O3 at the grain boundaries.

Effects of SnO2 addition on the magnetic properties of manganese zinc ferrites

Zn-doped SnO2 Nanoparticles: Structural, Optical, Dielectric and Magnetic Properties

Effects of Fe2+ content in raw materials on Mn–Zn ferrite magnetic properties

Dielectric and Magnetic Properties of (zn, Co) Co-Doped SnO 2 Nanoparticles

Co2O3 and SnO2 Doped MnZn Ferrites for Applications at 3–5 MHz Frequencies

Effect of Divalent Metal Ions Substitution on the Magnetic Properties of Ba3Co2-Me Fe24O41 (me = Zn2+, Ni2+) Hexagonal Ferrites

High-temperature Solid State Synthesis and Characterization in Magnetic and Transporting Properties of Zn_xFe_(3-x)O_4 Powder

Effects of MgO addition on the DC-bias-superposition characteristic of low-temperature-fired NiCuZn ferrites

Effect of Zn Substitution on Morphology and Magnetic Properties of Cufe2o4 Nanofibers

Effect of PbO–SiO2 and PbO–B2O3 flux systems on the crystalline and magnetic properties of Ni0.5Zn0.5Fe2O4 ferrite prepared from the mixed powders

Effects of Zn substitution on high-frequency properties of Ba1.5Sr1.5Co2-xZnxFe22O41 hexaferrites

Influence of Sr2+ Doping Quantity on Microstructure and Magnetic Performance of Z Type Hexagonal Ferrite

Study on Electromagnetic Properties of MnZn Ferrites with Fe-poor Composition

Origin of Ferromagnetism in Zn-doped SnO2 from First-Principles Study

Magnetic Properties of ZnO-doped Cobalt Ferrite

Effect of Mn substitution on the magnetic properties of MgCuZn ferrites

Effects of high Mn component on properties of NiCuZn ferrite

Magnetic and Electrical Properties of Low-Temperature Sintered Mn-doped NiCuZn Ferrites

The microstructures, magnetic properties and impedance analysis of Mn–Zn ferrites doped with B2O3

The Effect of Sintering Temperature on the Densification and Magnetic Performance of NiCuZn-Ferrites (CuO: 0–6 wt.%)

Effects of Zn substitution on high-frequency properties of Ba<sub>1.5</sub>Sr<sub>1.5</sub>Co<sub>2-x</sub>ZnxFe<sub>22</sub>O<sub> 41</sub> hexaferrites