Synthesis of styrene-maleic anhydride random copolymer and its compatibilization to poly(2,6-dimethyl-1,4-phenylene ether)/brominated epoxy resin

Guozheng Liang,Jiru Meng,Lei Zhao
DOI: https://doi.org/10.1002/pi.1153
IF: 3.213
2003-01-01
Polymer International
Abstract:Styrene-maleic anhydride random copolymer (R-SMA(7.5)), with a low content of maleic anhydride (MAH) of about 7.5 mol%, has been prepared, and the copolymer was characterized by fourier-transform infrared (FTIR) and C-13 NMR techniques showing that the product contained only random copolymer without blocks. The miscibility between poly(2,6-dimethyl-1,4-phenylene ether) (PPE) and R-SMA, was investigated by differential scanning calorimetry (DSC), showing that PPE was miscible with R-SNIA synthesized in our laboratory over the entire composition with low MAH content. A blend of R-SMA(18) (MAH content is about 18mol%) and PPE was also studied by DSC, which showed that PPE was immiscible when R-SNIA was the major component, although it was miscible with limited composition. FTIR investigation showed that R-SNIA could react with bromide epoxy (BEP) resin at high temperature (180degrees). The heat-resistance and mechanical properties of R-SMA/PPE/BEP systems were tested and analyzed, and results indicated that R-SNIA could improve the miscibility of PPE and BEP with increasing T-g of the BEP phase and decreasing the T-g of the PPE slightly, improving the breaking elongation and breaking energy, which resulted from good miscibility between PPE and BEP with R-SMA as the compatibilizer. Finally, the properties of the composites (copper clad laminate) with R-SMA(7.5) are studied and discussed. (C) 2003 Society of Chemical Industry.
What problem does this paper attempt to address?