Abstract:Co-pyrolysis of plastics and biomass is expected to replace traditional petroleum processing to produce BTEX (benzene, toluene, ethylbenzene, and xylenes) on a large scale, which are important chemical raw materials. The introduction of bimetallic catalysts and hydrogen in co-pyrolysis systems is an effective strategy to increase the content of aromatic hydrocarbons in pyrolysis oils, which has not been studied so far. The present study investigated the efficacy of bimetallic catalysts in enhancing aromatization and Diels-Alder reactions in comparison to Mo/ZSM-5. The synergistic interaction between bimetals contributed to the improved selectivity of aromatic hydrocarbons, particularly BTEX. Results revealed that NiMo/ZSM-5 catalysts led to higher aromatics selectivity in liquid oil, whereas FeMo/ZSM-5 resulted in higher BTEX selectivity in aromatic hydrocarbons. Moreover, metal oxide-supported bimetallic catalysts exhibited lower selectivity for aromatic hydrocarbons in liquid oil, despite facilitating higher liquid-oil yield. Among the metal oxide-supported bimetallic catalysts, FeMo/TiO2 demonstrated the highest selectivity (56%) for aromatic hydrocarbons in liquid oils. The introduction of hydrogen resulted in 100% selectivity of BTEX in aromatic hydrocarbons, thus highlighting the significance of hydrogenation in enhancing the selectivity of BTEX. Combined with the experimental results and literature, a possible reaction mechanism was also proposed.

Catalytic Epoxidation of Polyisobutylene‐co‐isoprene with Hydrogen Peroxide

Epoxidation of propylene to propylene oxide catalyzed by μ-oxo-bismetalloporphyrins

Catalytic Monoepoxidation of 1,3-Butadiene over Manganese Complex Catalysts

Activation of a Palladium-Based Catalyst by Hexafluoroisopropanol for Polyketone Synthesis Via Homogeneous Solution Polymerization

110Th Anniversary: the Epoxidation of Polybutadiene Via Reaction-Controlled Phase-Transfer Catalysis

Epoxidation Reaction of Cyclohexene over NaPMoO/ Ti-MCM-41

Synthesis of polyisoprene catalysized by molybdenum catalyst system

Bis(3-methyl-1-propene) ether and 3-(3-methyl-1-propene)-3-methyl-1,2-epoxypropane ether synthesis during the epoxidation of 1-butene-3-ol with hydrogen peroxide over the TS-2 catalyst

Polymerization of isoprene catalyzed with phosphates-modified molybdenum system

Mass Transfer and Reaction Kinetics of Soybean Oil Epoxidation in a Formic Acid‐autocatalyzed Reaction System

Photocatalytic Propylene Epoxidation with O2 over 4,4′-Dibromobenzophenone Modified Carbon Nitride Coupled with TS-1

Co-hydropyrolysis of Pine and HDPE over Bimetallic Catalysts: Efficient BTEX Production and Process Mechanism Analysis

Photocatalytic propylene epoxidation with O 2 over 4,4′-dibromobenzophenone modified carbon nitride coupled with TS-1

Effect of the Bipodal Ti Species on Activity and Selectivity of Propylene Epoxidation with H2O2 over TS-1: A Theoretical Study

Catalytic Behavior of Cobalt Complexes Bearing Pyridine–Oxime Ligands in Isoprene Polymerization

Catalytic epoxidation of palm oleic acid by heterogeneous catalysts: Optimization and kinetic model

Aliphatic Olefin Epoxidation with Hydrogen Peroxide Catalyzed by an Integrated Mn/TS-1/N System

Effect of the bipodal Ti species on activity and selectivity of propylene epoxidation with H 2 O 2 over TS-1: A theoretical study

Synthesis, Characterization, and Catalytic Behaviors in Isoprene Polymerization of Pyridine–Oxazoline-Ligated Cobalt Complexes

Study on Reaction Mechanism and Intrinsic Kinetics of Epoxidation of Propylene Catalyzed by TS-1 in Alcohols

Advantages of tandem versus simultaneous operation: The case of isomerization/hydrogenation of terpinolene epoxide to Terpinen-4-ol using a Ni/TiO2-SiO2 bifunctional catalyst