Abstract:The change in shock sensitivity of explosives having various explosive grain sizes is discussed. Along with other parameters, explosive grain size is one of the key parameters controlling the macroscopic behavior of shocked pressed explosives. Ignition and growth reactive flow modeling is performed for the shock initiation experiments carried out by using the in situ manganin piezoresistive pressure gauge technique to investigate the influences of the octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine (HMX) particle size on the shock initiation and the subsequent detonation growth process for the three explosive formulations of pressed PBXC03 (87% HMX, 7% 1,3,5-trichloro-2,4,6-trinitrobenzene (TATB), 6% Viton by weight). All of the formulation studied had the same density but different explosive grain sizes. A set of ignition and growth parameters was obtained for all three formulations. Only the coefficient G(1) of the first growth term in the reaction rate equation was varied with the grain size; all other parameters were kept the same for all formulations. It was found that G(1) decreases almost linearly with HMX particle size for PBXC03. However, the equation of state (EOS) for solid explosive had to be adjusted to fit the experimental data. Both experimental and numerical simulation results show that the shock sensitivity of PBXC03 decreases with increasing HMX particle size for the sustained pressure pulses (around 4 GPa) as obtained in the experiment. This result is in accordance with the results reported elsewhere in literature. For future work, a better approach may be to find standard solid Gruneisen EOS and product Jones-Wilkins-Lee (JWL) EOS for each formulation for the best fit to the experimental data.

Experimental and Numerical Study on the Shock Initiation of PBXC03 Explosive under the Different Loading Pressure

Embedded Manganin Gauge Measurements and Modeling of Shock Initiation in HMX‐Based PBX Explosives with Different Particle Sizes and Porosities

Effects of HMX Particle Size on the Shock Initiation of PBXC03 Explosive

Experimental research on differences of detonation growth process between HMX-based and TATB-based plastic bonded explosives

Numerical Research on Initiation of PBXC03 Explosives under Quasi‐Isentropic Loadings

Experimental research on effects of porosity on shock initiation of PBX explosive

Mesoscopic Effects on Shock Initiation of Multi-Component Plastic Bonded Explosives

Ignition and Growth Modeling of Shock Initiation of Different Particle Size Formulations of PBXC03 Explosive

Experimental and Numerical Calculation Study on Shock Sensitivity of Aluminum Explosive

A Mesoscopic Reaction Rate Model for Shock Initiation of Multi-Component Pbx Explosives

Influence Rule of Quasi-isentropic Loading Characteristics on the Initiation of PBXC03 Explosive

Investigation of Solid Explosives Initiation under Shock Waves

Shock to Initiation Characters of Heated Explosives with Different Confinement

Shock Initiation of Multi-Component Insensitive PBX Explosives: Experiments and MC-DZK Mesoscopic Reaction Rate Model.

A Modified Mesoscopic Reaction Rate Model for Shock Initiation of PBXs

Lateral rarefaction wave effects on shock initiation of heterogeneous condensed explosives

Investigation of the Deflagration to Detonation Transition in Pressed High Density Explosives

Shock Initiation of Explosives Investigated with Small Partition Experiment and Numerical Simulation

Two-dimensional Mesoscale Simulation of Shock Ignition in PBX Explosives

A Mesoscopic Reaction Rate Model for Shock-to-detonation of PBX Explosives Having Different Mean Particle Sizes

Initiation and Detonation Growth Characteristics of Polymer Bonded Explosives under Ramp-Wave Loadings