Abstract:The manifold microchannel heat sink shows great potential for cooling high-heat-flux electronic equipment owing to its exceptional thermal and flow performance. A new manifold ring-shaped channel design is introduced to improve the temperature uniformity for circular heat sources. A comparative analysis of the manifold straight channel, radial expansion channel and manifold ring-shaped channel designs is conducted based on the same heating area under equal mass flow conditions by numerical investigation using single-phase de-ionized water. The findings indicate that the newly proposed manifold ring-shaped channel design exhibits a lower maximum temperature, a lower average temperature, a better temperature uniformity and a smaller pressure drop in comparison to the straight channel and radial channel designs. Specifically, at a mass flow rate of 2.5 g/s, the ring-shaped channel design demonstrates a 71.4 % and 45.4 % reduction in the temperature difference between the maximum temperature and the minimum temperature of the heating surface, and the coefficient of performance is enhanced by 458.2 % and 169.7 % when compared to the straight channel and radial channel designs, respectively. Additionally, three improved designs based on the original manifold ring-shaped channel design are proposed to further enhance fluid flow distribution in the ring-shaped channel design. The results reveal that all three manifold ring-shaped channel optimizations further lower the maximum temperature, the average temperature and the temperature difference. Notably, the improved case3 exhibits the best thermal and hydraulic performances among all structures. When compared to straight channel and radial channel designs, the improved case3 demonstrates an 86.9 % and 75.0 % reduction in the temperature difference, and an increase of 201.2 % and 523.4 % in coefficient of performance under the equal mass flow comparison basis. A heat flux of 1200 W/cm2 can be dissipated at 6 g/s when the maximum temperature rise is kept below 60 K, with a pressure drop of 38 kPa.

Numerical investigation on flow distribution characteristics of U type and Z type manifold of cold box

Structural Optimizations of U‐ and Z‐Type Manifolds for Uniform Flow Distribution by Applying an Increaser and Baffle Plates

Segmented Design of Performance Enhancement for Large Plate Fin Heat Exchanger of Cryogenic Air Separation Unit

Numerical Analysis of Header Structure Improvement in a Plate-Fin Heat Exchanger

Effects of Distribution Channel Dimensions on Flow Distribution and Pressure Drop in a Plate‐Fin Heat Exchanger

A numerical and experimental study of chevron, corrugated-plate heat exchangers

Numerical Study on Novel Design for Compact Parallel-Flow Heat Exchanger with Manifolds to Improve Flow Characteristics

Thermal and hydrodynamic characteristics of single-phase flow in manifold microchannels with countercurrent regions

Numerical study on hydrodynamic characteristics of plate-fin heat exchanger using porous media approach

Effect of Inlet Flow Maldistribution on the Passage Arrangement Design of Multi-Stream Plate-Fin Heat Exchanger

Performance Improvement of Z-Type Manifold Microchannel Heat Sink with Novel Fin-Arrangements

Influence of fluid distributors on the performance of the industrial cold box with a plate-fin heat exchanger: A numerical study

Study on the flow and heat transfer characteristics of pin-fin manifold microchannel heat sink

Numerical investigation of novel manifold microchannel heat sinks with countercurrent regions

Flow Manifold Optimization for a Uniform Velocity Distribution in a Laminated Microreactor with Micro‐Pin‐Fin Arrays

Numerical Analysis of H-type Finned-tube Heat Exchanger

An optimization method for uniform flow distribution in the manifold of server cabinet

A Comparative Numerical Study on Two-Phase Boiling Fluid Flow and Heat Transfer in the Microchannel Heat Sink with Different Manifold Arrangements

Numerical Study on a New Manifold Ring-Shaped Microchannel Structure for Circular Heat Source with Excellent Temperature Uniformity

An experimental study of the influence of the temperature difference field uniformity on cross-flow heat exchanger performance

Cooling Air Flowrate Distribution Among Parallel Heat Exchangers