Abstract:Due to the stratified construction of additive manufacturing (AM), the building orientation of an object greatly affects the manufacturing process and quality of the products. This article proposes an optimization algorithm for AM that comprehensively covers the three main aspects affected by the building direction: efficiency, surface quality, and internal properties. The goal of optimizing efficiency is to cut the manufacturing and postprocessing times by reducing the support volume. In terms of surface quality optimization, a new and comprehensive mathematical model is established. Considering not only the influence of the stepping effect on the whole model but also the supporting contact area, the optimization to the salient area was innovatively proposed. The salient area was defined by cone curvature, which has a significant influence on appearance. Another novel point is the quantitative optimization of the internal properties, which is based on the anisotropic characteristics of AM. The mechanical properties are taken into consideration in this article, and other anisotropic properties can be added to the optimization algorithm by using the same method. Afterward, a particle swarm optimization algorithm was adopted to synchronously optimize the targets just cited, according to the degree of importance of each factor for specific applications. The algorithm was implemented to optimize several different cases with different characteristics. Further, the results in the experiments manifested that the models printed in the optimized orientation performed better than the initial models, and the corresponding comprehensive evaluation scores were improved as well, with an optimization range of 70-90%. And the rate of optimization for support volume, surface roughness, salient area roughness, and maximum tensile strength, respectively, reached 20.9%, 57.3%, 59.5%, and 293.0%.

Application of Multi-objective Particle Swarm Optimization in Sheet Metal Forming

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Multi-objective Robust Optimization of Injection Molding Process Parameters Based on TOPSIS

Multiobjective Optimization of Injection Molding Parameters Based on Soft Computing and Variable Complexity Method

Parameters Optimization of Tailor Welded Blank Forming Process

Sheet metal forming optimization by using surrogate modeling techniques

A Robust Optimization Design Method for Sheet Metal Roll Forming and Its Application in Roll Forming Circular Cross-Section Pipe

Building Orientation Determination Based On Multi-Objective Optimization For Additive Manufacturing

Process Parameters Optimization for Sheet Metal Forming During Drawing with a Multi-Objective Genetic Algorithm

Multi-objective optimization with automatic simulation for partition temperature control in aluminum hot stamping process

Multiobjective Optimization Based on Response Surface Model and Its Application to Engineering Shape Design

Optimization method of flexible job-shop scheduling based on multiobjective particle swarm optimization algorithm

A 6-Sigma Robust Optimization Method for Stamping Forming of Automobile Covering Parts Based on Residual Error and Radial Basis Interpolation

Numerical multi-objective optimization of segmented and variable blank holder force trajectories in deep drawing based on DNN-GA-MCS strategy

Small Sample Data-Driven Multi-Objective Optimization of MEMS Sensor Molding Process Parameters

Springback Control in Complex Sheet-Metal Forming Based on Advanced High-Strength Steel

A multi-objective optimization using response surface model coupled with particle swarm algorithm on FSW process parameters

Multi-Objective Optimization of Dimensional Accuracy in Electric Hot Incremental Sheet Forming

Optimization of riveting parameters using Kriging and particle swarm optimization to improve deformation homogeneity in aircraft assembly

Multi-Objective Optimization of Inertia Equilibrium in Ultra High Speed Stamping Machine

Application and development of algorithm for sheet hydro-forming in numerical simulation