Abstract:A method based on a dual-channel gas chromatograph equipped with three columns and three detectors was established for the determination of individual components in finished motor gasoline. The gasoline samples were separately introduced into the two injection ports of the chromatograph using two autosamplers. The components of the sample introduced into the first injection port (channel 1) were separated on a nonpolar PONA column (50 m×0.20 mm×0.5 μm) for gasoline analysis and detected by an flame ionization detector (FID). The components of the sample introduced into the second injection port (channel 2) were separated on another PONA column. Oxygenates (e.g., ethers and alcohols), other unconventional and prohibited additives that would co-elute with the hydrocarbons (e.g., methylal, dimethyl carbonate, sec-butyl acetate, and anilines), and some difficult-to-separate hydrocarbon pairs (e.g., 2,3,3-trimethylpentane and toluene) eluted from the PONA column and entered a DM-624 column (30 m×0.25 mm×1.4 μm) to achieve further separation according to the switch timetable using the Deans switch procedure and detected by an FID. The peak of 3-methylpentane, a common component in gasoline samples, also entered the DM-624 column by the Deans switch procedure for calculation purposes. The peak areas of target components on the PONA column in channel 1 were calculated using the peak areas on the DM-624 column as well as those of 3-methylpentane on both the DM-624 and PONA columns in channel 1 with a calibration factor between the two channels. The peak areas of co-eluted components were obtained by subtracting the calculated peak areas of the target components from those of the co-eluted peaks. The mass percentages of the individual components were calculated according to the normalization method using all peak areas on the PONA column in channel 1 with relative response factors. The mass percentages of the oxygenates, anilines, and individual hydrocarbons were determined, and the group-type distribution was calculated according to the carbon number. Separation and quantitation interferences between the additives and hydrocarbons were eliminated using this procedure. Twenty oxygenates and unconventional additives, each with a mass percentage of approximately 3%, were added to a real motor gasoline-92 sample and analyzed using the proposed method. The recoveries of the target components were between 90.1% and 118.2% with relative standard deviations (RSDs) between 0.2% and 5.1% (n=6). The analysis of a real ethanol-gasoline sample showed that the RSDs of contents of most components was less than 3% (n=6). Because the heart-cut of peaks using Deans switch technique requires the precise repeatability of retention times, the retention-time repeatability of components on the PONA column in channel 2 was investigated over an extended period of time after thousands of runs of real-sample analysis. The retention times of the same component in several randomly selected motor gasoline-92 samples varied from 0.01 to 0.03 min, indicating that the proper timetable for the Deans switch remained stable for two years. The precise repeatability of retention times was achieved owing to the high precision of the electric pneumatic control of the chromatograph and the stability of the column used. Real finished motor gasoline samples with different octane numbers (gasoline-92, gasoline-95, and ethanol gasoline-95) were analyzed using the developed method, and the results acquired were consistent with those of standard methods (GB/T 30519-2016, NB/SH/T 0663-2014, and SH/T 0693-2000). If some unconventional additives (such as methylal) were added to gasoline samples, the contents of these unconventional additives could also be detected, which means one run of the proposed method could provide results corresponding to three or four runs of different standard methods. The acquisition of information on the individual components of finished motor gasoline will assist in research on precise gasoline blending.

Determination of Main Components in Wash Oil by Gas Chromatography

Simultaneous Determination of Seven Components of Volatile Oil in Elsholtzia Blanda by Headspace Gas Chromatography

Determination of Glucosinolates by Liquid Chromatography-Mass Spectrometry

Determination of the low boiling point components in tobacco by thermal desorption-gas chromatography-mass spectrometry

Extraction of Fish Sauce Flavor Compounds and Optimization of Gas Chromatographic Separation Conditions

Determination of CO, CO2 and Light Hydrocarbons in Air by Gas Chromatography

Quantitative assessment of gas washing of oils in the Tazhong area of the Tarim Basin, Northwest China

Determination Of Fatty Acids In Vegetable Oils Using Comprehensive Two-Dimensional Gas Chromatography Coupled To Quadropole Mass Spectrometry

Determination of Unsaturated Hydrocarbons in Oil and Its Processing Products by Capillary Gas Chromatography and High-Performance Liquid Chromatography

Study on Simultaneous Determination of Five Components in Xiaoyan Zhentong Gao by GC

Determination of Triadimefon-Copper 25% WP by GC

[Determination of individual components in finished motor gasoline by dual-channel three-column gas chromatography]

[Determination of Underivatized Long-Chain Fatty Acids in Edible Oils by Fast Gas Chromatography].

Determination of Components in Fraction of C7-C9 of the Coal-Liquefied and Hydrogenated Oil by GC-MS in Combination with the Method of Live Database

Universal Method For The Fraction Separation And The Gain Of Coupling Information Of Chromatography And Mass-Spectrum In Systematic Analyses Of Structures And Contents Of Non-Hydrocarbon Compounds In Crude Oils By Combining With Chemometrics

Analysis of Hydrocarbon Group Composition of Light Crude Oil by Capillary Gas Chromatography

Analysis of sulfur-containing odorous gas mixture by capillary gas chromatography

Analysis Of Components In C-9 Fraction By Gas Chromatography-Mass Spectrometry And Gas Chromatography-Infrared Spectroscopy

Evaluation of Gas Chromatography-Mass Spectrometry in Conjunction with Chemometric Resolution for Identification of Nitrogen Compounds in Crude Oil

Systemic Analysis of Structures and Contents of Nitrogen-containing Compounds and Other Non-Hydrocarbons in Crude Oils in Conjunction with Chemometric Resolution Technique

The Method for Analysis of Hydrocarbon Mixtures C1‐C5 by Capillary Column Gas Chromatography