Abstract:IAPWS-IF97 is widely applied to computations of thermodynamic property for water and steam; however, the proposed computation algorithm is not high efficient enough to complicated applications such as heat cycles optimization and as database for computational fluid dynamics software. This paper proposed a rapid and accurate computation scheme based on double-grid, bi-quadratic spline interpolation scheme for calculating thermodynamic properties of water and stream on p-T thermodynamic surface. The computational region proposed is valid at 273.16-1073.15 K and 0.001-100 MPa, covering IAPWS-IF97 regions 1-4. To resolve the discontinuity problem for thermodynamic properties and their derivatives in the vicinity of the saturated line and in the critical region, the division of computational region is divided in to thirty-two sub-regions with adopted equidistant grids in each sub-region. A boundary normalization approach is proposed to convert the sub-regions with saturated line or pseudo-critical temperature curve as boundary into rectangular computational region. Then the spline functions g(SPL)(p,T), rho(SPL)(p,T), s(SPL)(p,T) and h(SPL)(p,T) are determined based on data by IAPWS-95 formulation. All tested results revealed superior performance in both computation speed (10.8-642 times faster) and prediction consistency (1-2 orders better) for the present interpretation scheme than the IAPWS-IF97. (C) 2012 Taiwan Institute of Chemical Engineers. Published by Elsevier B.V. All rights reserved.

The Application of Fitting Formula for Specific Volume and Enthalpy of Water and Steam in the Saturated Steam Industrial Boiler

Thermodynamic properties calculation method for moist air: 173 to 647 K

Efficient and Accurate Computation Scheme of P–t Thermodynamic Properties of Water and Steam

Rapid Calculation for Density of Water and Steam on P-T Thermodynamic Surface

Formula of Static Pressure Distribution Parameters for Calculating the Static Pressure Distribution in Distributing Headers of Utility Boiler

Fast Calculation of Thermodynamic Properties of Water and Steam on p-h Thermodynamic Surface

Extension of the IAPWS-95 formulation and an improved calculation approach for saturated properties

Calculation of the Flow Rate Deviation Factor of a Boiler Water-wall When the Pr essure Drop of Water/steam Two-phase Flow has been Taken into Account

Efficient Evaluation of Thermodynamic Properties of Water and Steam on P–h Surface

Wetness-measuring instrument with two directly heating sleeve pipes for flowing wet steam

A Study of Frictional Resistance Characteristics of High-pressure Steam-water Two-phase Flows

Hydraulic and thermal coupling calculation for the steam pipe network of ships

High Pressure Steam–water Two-Phase Flow Measurements by Flow Division and Separation Method

An Experimental Study on Distribution Characteristics of High Pressure Steam-Water Two-Phase Flow

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model

Comparative Study on Water Thermodynamic Property Functions of TRACE Code

Flow Characteristic of Steam Jet Condensed into a Water Pipe Flow - a Numerical Study

Development of Software for Thermal Test of Boiler

Flow Distribution Characteristics of Intermediate Headers of a Supercritical Once-through Boiler's Water Cooled Walls, Operating Under Variable Pressure Conditions

Steam Network Hydraulic Calculation by Section Integral Method

A New Method for Calculating Hydrodynamics of Corner-Tube Boiler Based on Differential Pressure Solution