Abstract:Nickel-based superalloys are essential materials for turbine engine components in aerospace applications. However, it is difficult to manufacture nickel-based superalloys with high surface integrity due to the high cutting forces, high cutting temperatures, and severe work hardening, which usually requires cutting tools with good thermal conductivity, superior high-temperature performance, and high abrasion resistance. This paper investigates the tool wear mechanism and machined surface integrity of the refractory powder metallurgy nickel-based superalloy FGH 4097 during milling at different speeds, with a special focus on the effect of various coatings (TiAlCrN, TiAlN, and TiAlSiN). The relationship between tool flank wear (VB) and material removal volume (MRV) was studied, and the cutting force signals were analyzed in both the time and frequency domains. This work also examined the influence of tool wear with various coatings on both the surface morphology of machined parts and the distribution of residual stress. Furthermore, the mechanisms of tool wear for different coatings were revealed by analysis using scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS). The results demonstrated that the wear characteristics on the three coated tools were similar during milling at a lower speed. However, the TiAlCrN coated tool demonstrated superior performance at high cutting speed. For the identical coated tools, the cutting force and roughness of the surface increased with the elevation of cutting speed when holding an identical amount of MRV. The SEM and EDS analysis revealed that adhesive wear was found to be the dominant mechanism of tool wear for the tested tools, regardless of the coatings used, while the TiAlN-coated tool also exhibited abrasive wear.

An Overview of Tool Friction and Wear Behavior in High-speed Machining-typical Difficult-to-cut Material

Tool Wear in Disk Milling Grooving of Titanium Alloy

NEW PERSPECTIVES ON THE CUTTING MECHANISM OF DIFFICULT-TO-MACHINE MATERIALS

Wear patterns and mechanisms of cutting tools in high-speed face milling

Wear Mechanism Analysis of Coated Carbide Tools in High-Speed Milling of Ti-6al-4v Alloy Via Cross-Section Characterization of Worn Cutting Edge

Tool Diffusion Wear Mechanism in High Efficiency Machining Ti6Al4V

Tool Wear in High-Speed Milling of Ti-6al-4v Alloy

Understanding Tool Cutting-Edge Microstructure and Deformation Mechanism Induced by Adhesive Wear in the Turning of Nickel-Based Superalloys

Friction and Wear of Cutting Tools and Cutting Tool Materials

Tool Wear in Nickel-Based Superalloy Machining: an Overview

Wear and Failure Mechanisms of SiAlON Ceramic Tools During High-Speed Turning of Nickel-Based Superalloys

Tool wear characteristics in machining of nickel-based superalloys

Tool wear behaviors and corresponding machined surface topography during high-speed machining of Ti-6Al-4V with fine grain tools

Analysis of tool wear and cutting characteristics in milling of powder metallurgy nickel-based superalloy by various coatings

Adhesion Wear on Tool Rake and Flank Faces in Dry Cutting of Ti-6al-4v

High surface integrity machining of typical aviation difficult-to-machine material blade

Research on Wear Mechanisms While Turning Titanium Alloy Tc4

Anti-Friction and Anti-Wear Mechanisms of Micro Textures and Optimal Area Proportion in the End Milling of Ti6Al4V Alloy

Friction behaviors in the metal cutting process: state of the art and future perspectives

Research on High Speed Cutting Tribology

Enhancing the Machining Performance by Cutting Tool Surface Modifications: a Focused Review