Abstract:TiAl intermetallic alloys have attracted considerable attention in aerospace applications over the last few decades owing to their low density and superior mechanical properties at high temperatures. However, these alloys are also known as difficult-to-machine materials that hinder efficient manufacturing. This study presents a systematic investigation on the machinability of TiAl alloys with three types of microstructures obtained by different heat treatment parameters. These were classified as near-gamma (NG), duplex (DP), and fully lamellar (FL). The machinability was evaluated based on the cutting forces and machined surface roughness. The material with α2/γ lamellar structures (FL) exhibited the lowest cutting force (3.21 N). However, produced a rougher surface (80 nm Ra) as compared to the NG microstructure (4.69 N and 47 nm Ra). Electron backscattering diffraction (EBSD) evaluation of the primary deformation zone in the cutting chips revealed that insufficient heat energy was converted from plastic deformation for recrystallization or β+γ→α2 phase transformation to occur. This indicated that the deformation mechanisms were significantly dependent upon the plasticity. The NG microstructure demonstrated a higher degree of plasticity in the primary deformation zone, which was attributed to the combined effect of super-dislocation decomposition, ordinary dislocation slip, and refined mechanical twins with preferred orientation along the < 11 2 ¯ > {111} crystallographic orientation. Conversely, the FL microstructure exhibited brittleness during chip formation due to the weak bonding force between hexagonal α2 and tetragonal γ phases that led to preferential micro-cracking along each interface. Reducing the crystal orientation is conductive for improving machined surface quality. The notion of enhanced brittleness to explain the reduction in cutting forces due to the dissipation of energy through fracture was supported with numerical simulations. Microscopic evaluation was used to understand the deformation differences of the equiaxed γ grain and α2/γ lamellar microstructure during micro-cutting. Additionally, enhanced the understanding of the deformation mechanism of these multi-phase alloys.

NEW PERSPECTIVES ON THE CUTTING MECHANISM OF DIFFICULT-TO-MACHINE MATERIALS

Mechanism of Saw-Tooth Chip Formation of Titanium Alloy Based on Finite Element Simulation

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

The Finite Element Analysis Of Serrated Chip Formation In High-Speed Cuffing Auto Panel Dies

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

High surface integrity machining of typical aviation difficult-to-machine material blade

Effect of cutting conditions on the serrated chip formation in high-speed cutting

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Understanding The Deformation Of Metals In High Speed Cutting

Machining mechanism and stress model in cutting Ti6Al4V

Overcoming challenges: advancements in cutting techniques for high strength-toughness alloys in aero-engines

Numerical Investigation on the Effect of Cutting-Edge Shape Factor on the Cutting Performance of Titanium Alloy

Molecular Dynamics Simulation Study on the Influence of the Abrasive Flow Process on the Cutting of Iron-Carbon Alloys (α-Fe)

Research on surface integrity and its influencing factors in the high-speed cutting of typical aluminum/titanium/nickel alloys: a review

Influence of Tool Materials on Machinability of Titanium- and Nickel-Based Alloys: A Review

The state of the art for numerical simulations of the effect of the microstructure and its evolution in the metal-cutting processes

On understanding the specific cutting mechanisms governing the workpiece surface integrity in metal matrix composites machining

Research status and development trend of cutting surface integrity of aerospace alloy materials

Microstructural modulation of TiAl alloys for controlling ultra-precision machinability

Machinability improvement of titanium alloys in ultra-precision machining with micro-structured surface

Research progress in machining technology of aerospace thin-walled components