Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Electromagnetic-Thermal Characteristics of Mcp Bscco-2212 Tube During Quenching Process in Self-Field

Two Quenched Models for High-Temperature Superconducting Insulated Coils

Electromagnetic Field and Temperature Field Analysis of Coil Type Lead-Bismuth Electromagnetic Flowmeter

Study of AC Loss and Temperature Distribution of a BSCCO Coil Cooled in Liquid Nitrogen or Using a Cryocooler

Superconductivity in an Arc Melted MoCx

Numerical Simulation of Electromagnetic Phenomena and Solidification under a Pulsed Magnetic Field

A General Model for Simulating the Quench Behavior of Canted-Cosine-theta (CCT) Quadrupole Magnets

Numerical Study on Thermal Stability of No-Insulation Coils Using a Three-Dimensional Finite-Element Model

Investigation on intense axial magnetic field shielding with a large melt cast processed Bi-2212 tube

Electromagnetic-thermal coupling behaviors and thermal convection during two-phase zone continuous casting high strength aluminum alloy tube

Quench characteristics in the multi-sectioned superconducting magnet impregnated with epoxy resin

Holistic numerical simulation of a quenching process on a real-size multifilamentary superconducting coil

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Simulation of Thermo-Mechanical Stresses After a Quench in the 15 T Test Facility Dipole Magnet

Effect of M-EMS current intensity on the subsurface segregation and internal solidification structure for bloom casting of 42CrMo steel

Thermal-hydraulic Analysis on Quench Behavior of Indium-Tin Soldered REBCO Composite Conductor

Modeling And Simulation Of Induction Heating With Magnetic Flux Concentrator

An electromagnetic-thermal-mechanical coupling model of dry-wound HTS coil based on T-A formulation with Neumann boundary condition

Influence of Current Diffusion in Superconducting Magnet Fabricated by High Stabilizer Aluminum on Quench Propagation

Modeling and simulation on the magnetization in field-cooling and zero-field-cooling processes

Electromagnetic-thermal-mechanical behaviors of a no-insulation double-pancake coil induced by a quench in the self field and the high field