Abstract:Electrospray ionization (ESI) mass spectrometry can be divided into three steps: Nebulization of a sample solution into electrically charged droplets, liberation of ions from droplets, and transportation of ions from the atmospheric pressure ionization source region into the vacuum and mass analyzer of the mass spectrometer. A sample solution is fed through a capillary tube and a high electric field at the tip of the tube pulls positive charge towards the liquid front. When electrostatic repulsion becomes stronger than the surface tension, a small electrically charged droplet leaves the surface and travels through the surrounding gas to the counter-electrode. Under the majority of experimental liquid chromatography–mass spectrometry and capillary electrophoresis–mass spectrometry conditions, positive charge on droplets is generated by the removal of negative charge via electrochemical discharge of negative ions against the metal wall of the spray capillary. When the ESI source is set up for the detection of negative ions, all power supplies are at reversed polarity. Removal of positive ions inside the tip of the spray capillary provides droplets depleted of positive charge. The supply of negative charge to the solution may also take place; electrons released from the spray capillary can be captured by sample molecules having a high electron affinity. Droplet size decreases and charge density at the droplet surface increases after droplet disintegration and solvent evaporation. When the electric field at the surface of a droplet has become sufficiently high, ions are emitted from the droplet surface into the surrounding gas and are sampled by the mass analyzer. Sample ion intensity is dependent on ion structure and is affected by solvent composition and presence of additives. ESI behaves as a concentration sensitive detector for chromatography. When the sample concentration is increased above 10 μM, the sample ion signal saturates, which can be explained by the assumption that the surface of ion-emitting droplets is full at 10 μM. Sample ion abundance over a wide m/z range is further affected by inherently mass-dependent efficiencies of ion transportation, ion separation and ion detection.

Evaluation of Ion Transport Processes in A Heated Capillary Tube Interface for Electrospray Ionization Time-Of-Flight Mass Spectrometry - Invited Lecture

Ion transfer between ion source and mass spectrometer inlet: electro-hydrodynamic simulation and experimental validation

Experimental and Simulation Investigation of Ion Transfer in Different Sampling Capillaries.

Electrochemical Aspects of Electrospray and Laser Desorption/Ionization for Mass Spectrometry

Numerical modeling of ion transport in a ESI-MS system

A study of the transient gas flow affected ion transmission in atmospheric pressure interfaces based on large eddy simulation for electrospray ionization mass spectrometry

Observation of Large, Charged Droplet Signatures within the High-Vacuum Region of a Commercial Electrospray TOF-MS

A Simplified Electrospray Ionization Source Based On Electrostatic Field Induction For Mass Spectrometric Analysis Of Droplet Samples

Atmospheric Pressure Interface for a Handheld Ion Trap Mass Spectrometer: Electrospray Ionization and Desorption Electrospray Ionization

Time-of-flight mass spectrometry with an electrospray ion beam

Induced Self-aspiration Electrospray Ionization Mass Spectrometry for Flexible Sampling and Analysis.

Direct ion imaging approach for investigation of ion dynamics in multipole ion guides

Implementation of Ion/ion Reactions in a Quadrupole/time-of-flight Tandem Mass Spectrometer.

Mechanistic aspects of electrospray ionization

About the Electrospray Ionization Source in Mass Spectrometry: Electrochemistry and On-chip Reactions

Following the Ions Through a Mass Spectrometer with Atmospheric Pressure Interface: Simulation of Complete Ion Trajectories from Ion Source to Mass Analyzer.

Electrospray Propulsion Time-of-Flight Secondary Ion Mass Spectrometry Diagnostic

A modified time-of-flight mass spectrometer for studying ion-molecule or neutral particle-molecule interactions

Practical implications of some recent studies in electrospray ionization fundamentals

Electroless Ionization Mass Spectrometry Using a Compact Electrokinetic Ionization Source

Flowing Gas in Mass Spectrometer: Method for Characterization and Impact on Ion Processing.