Abstract:Although turbulent flow is generally needed for good suspension of photocatalysts, lower flow rates are preferred from an economic viewpoint for energy-efficient operation. However, no experimental work has been conducted to reveal how photocatalyst particles move and distribute in a tubular photocatalytic reactor under mild operating conditions, which is critical for reactor design and configuration of the light concentration. In our study, the photocatalyst itself was employed as a tracer particle for Particle Image Velocity (PIV) measurement. PIV combined with a new laser sheet image analysis (LSIA) technology was employed to investigate both the particle velocity and number distribution in the tubular reactor. It was found that, in the inlet, a higher velocity distribution of fluid generally occurred in the lower part of the tube. However, in the middle and outlet regions of the tube, a higher velocity distribution existed in the upper part of the tube. LSIA investigation showed that the transport capacity of the fluid and the initial particle size distribution are two essential factors influencing particle number distribution in the suspension. Regardless of the particle size, the middle part of the reactor holds the maximum number of particles while the outlet has the minimum number of particles. In the inlet, both small and large particles show similar number distribution trends against the flow rate. However, in the middle part of the tube, the number of small particles decreases with the flow rate while the number of the large particles shows the opposite trend. The difference in velocity distribution along the radial direction also significantly affects the particle distribution. One interesting finding is that, regardless of the particle size, the number of particles in the upper part of the tube is always higher than that in centre. Stokes’ drag law and the Saffman lift force were employed to explain this experimental finding. In the last section, the correlation between particle distribution and optical properties was numerically investigated by a modified differential approximation (MDA) method.

Numerical investigations of catalyst–liquid slurry flow in the photocatalytic reactor for hydrogen production based on algebraic slip model

Catalyst particle distributions in photocatalitic reactor for hydrogen production based on asm model

Influence of Slurry Velocity and Concentration Distributions on Fischer-Tropsch Synthesis in Slurry Bubble Column Reactor

Research on the Design and Application of Efficient Catalysts Based on Interfacial Chemistry: Molecular Catalysts in Gas-Liquid Mixed Systems

Computational Fluid Dynamics Modeling of Reactive Multiphase Flow for Suspended Photocatalytic Water Splitting of Hydrogen Production System

Insights into the Hydrodynamic Properties of Slurry Flow in a Tubular Photocatalytic Reactor by PIV Combined with LSIA

Photocatalytic Hydrogen Production from Refinery Gas over A Fluidized-Bed Reactor I: Numerical Simulation

Numerical Modeling of Microchannel Reactors with Gradient Porous Surfaces for Hydrogen Production Based on Fractal Geometry

Investigation and Modeling of Cpc Based Tubular Photocatalytic Reactor for Scaled-Up Hydrogen Production

Study on Particle and Photonic Flux Distributions in a Magnetically Stirred Photocatalytic Reactor

Experimental study of direct solar photocatalytic water splitting for hydrogen production under natural circulation conditions

Numerical Modeling of Microchannel Reactor with Porous Surface Microstructure Based on Fractal Geometry

Study on the Radiation Distribution in A Fluidized Tubular Reactor for Heterogeneous Photocatalytic Hydrogen Production

Study on the Hydroxyl Synthesis in Circulating Slurry Reactors

Comprehensive Study on Novel Parabolic Trough Solar Receiver-Reactors of Gradually-Varied Porosity Catalyst Beds for Hydrogen Production

Numerical simulation on flow and heat transfer characteristics of slush hydrogen in horizontal pipe

Periodical Oscillation of Particle-Laden Laminar Flow Within a Tubular Photocatalytic Hydrogen Production Reactor Predicted by Discrete Element Method

An Innovative Micro-Channel Catalyst Support with a Micro-Porous Surface for Hydrogen Production Via Methanol Steam Reforming

Lattice Boltzmann Simulation of Substrate Flow Past a Cylinder with PSB Biofilm for Bio-Hydrogen Production

Investigation of Hydrogenation and Mass Transfer Performance in Micropacked Beds with Highly Active Monolithic Catalysts

Numerical study on novel parabolic trough solar receiver-reactors with double-channel structure catalyst particle packed beds by developing actual three-dimensional catalyst porosity distributions