Abstract:Passive transmission line (PTL) has been widely applied in rapid single flux quantum (RSFQ) circuits, especially as the first choice of long-distance transmission in large-scale integrated circuits such as arithmetic and logic unit (ALU) and central processing unit (CPU). With the increasing demand of timing regulation, general bias margin is not enough to evaluate the performance of PTL circuits. Timing accuracy including propagation delay of the micro stripe line (MSL) and its delay skew is more critical for clock routine and signal transmission when employing PTL circuits. However, the related reports about the timing information of PTL circuits is limited in the single-value verification of the theoretical MSL's delay. More factors such as bias current, transmission length and system noise should be considered into the evaluation of the PTL circuits. This work focuses on the timing extraction of the designed PTL circuits through different control groups, and evaluates the timing discrepancy between the measurement and simulation. We adopt the method of time accumulation by increasing different lengths of MSL in the loop of the ring oscillator (RO) and subtract each other to evaluate the MSL's propagation delay. We analyzed MSLs of two layers (MSL1 and MSL2). The measured propagation delay of 1 ${\text{mm}}$ MSL is 8.20 psmm for MSL1 and 7.66 psmm for MSL2, which has a delay skew of 0.30 ${\text{ps}}$ and 0.57 ${\text{ps}}$ from the simulated value (8.23 ${\text{ps}}$). Within MSL transmission length of 5 ${\text{mm}}$, a maximum deviation of 1.2 ${\text{ps}}$ is adopted as time redundancy of PTL circuits applied in ALU and CPU design.

Design of time delay lines with periodic microstrip line and composite right/left-handed transmission line

An Active Circulator-Based Delay Line

On-chip delay line based on selection network

Lossless Microwave Photonic Delay Line Using a Ring Resonator with an Integrated Semiconductor Optical Amplifier

A structure optimization for integrated binary reconfigurable true time delay lines

An 800-Ps Origami True-Time-Delay-Based CMOS Receiver Front End for 6.5–9-Ghz Phased Arrays

Design of a compact rat-race coupler employing electromagnetic bandgap (EBG)-loaded and composite right/left-handed (CRLH) half-mode substrate integrated waveguides (HMSIWs)

Miniaturized overlapped LC phase delay line

A Compact 1–11-GHz 106.7-ps CMOS Passive True Time Delay Chain Implemented by Spiral Transmission Lines

The Design of a Novel 2-42 GHz MEMS True-Time Delay Network for Wideband Phased Array Systems

Performance of a silicon-microring slow-light delay line for advanced modulation formats

Timing Evaluation of Passive Transmission Line by RSFQ Ring Oscillator

Investigations on Delay Interconnect Lines for High-Speed Designs with the Numerical Technique

Photonics for Time Delay in Communication Systems

A Compact 3–20-Ghz 106-Ps Passive True-Time Delay Circuit in 65-Nm CMOS

Integrated Optical True Time Delay Module Based on Optical Wavelength Router

System Performances of On-Chip Silicon Microring Delay Line for RZ, CSRZ, RZ-DB and RZ-AMI Signals

Fabrication and characterization of delay lines with spoof surface plasmon polariton waveguide coupled with C-shaped metamaterials for microwave integrated circuits

Active Microwave Metamaterials Incorporating Ideal Gain Devices

Differential Microstrip Lines with Reduced Crosstalk and Common Mode Effect Based on Spoof Surface Plasmon Polaritons.

A field tunable multichannel microwave delay-line using a piezoelectric-piezomagnetic superlattice