Abstract:The conventional electrodes of direct methanol fuel cells (DMFCs) usually encounter a problem that the catalysts sink into the diffusion layer after a period of operation, causing a lowered catalyst utilization and degraded cell performance. Aiming to alleviate this problem, in this work a novel anode electrode structure is proposed, in which a micro porous layer containing Nafion polymer is added between the catalyst layer and the microporous layer with PTFE. The presence of the Nafion-contained layer can expand the three-phase interface region of the electrochemical reactions and improve the utilization of the catalyst. The single cell test showed that the peak power densities of the novel membrane electrode assembly (MEA) fed with 0.5 M and 2 M methanol solutions reached 38.35 mW cm(-2) and 101.82 mW cm(-2), which increased by 100.42% and 15.27% compared with those of conventional single microporous layer. Electrochemical impedance spectroscopy (EIS) measurements indicated the charge transfer resistance of the conventional MEA structure was increased by 303.78%, while the new one was decreased by 47.91% after continuously operating for 48 h. The anode electrochemical active surface area (ECSA) values of the novel MEA and the conventional MEA were 52.6 m(2) g(-1) and 44.3 m(2) g(-1). These experimental results showed that the performance of the double microporous layer MEA was higher than that of the conventional MEA. This new microporous layer structure is promising to be used in fuel cells to improve cell performance and alleviate performance degradation after long-term operating. (C) 2019 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

A Novel Structure of MEA for Air-Breathing DMFC

A novel MEA architecture for improving the performance of a DMFC

Development of Cathode Ordered Membrane Electrode Assembly Based on TiO2 Nanowire Array and Ultrasonic Spraying

Improving Cell Performance and Alleviating Performance Degradation by Constructing a Novel Structure of Membrane Electrode Assembly (MEA) of DMFCs

A Novel Electrode Architecture for Passive Direct Methanol Fuel Cells

Investigation of a Novel MEA for Direct Dimethyl Ether Fuel Cell

Optimization of Membrane Electrode Assembly in Air-Breathing Direct Methanol Fuel Cell

High Performance Membrane Electrode Assembly with Ultra-Low Platinum Loading Prepared by a Novel Multi Catalyst Layer Technique

Fabrication of High-Performance Gas Diffusion Electrode Via Microporous Layer Surface Morphology Control

Performance of an integrated composite membrane electrode assembly in DMFC

One Simple Method to Improve the Mass Transfer of Membrane Electrode Assembly to Realize Operation under Wide Humidity

Structural Design of Gas Diffusion Layer for Proton Exchange Membrane Fuel Cell at Varying Humidification

An Asymmetric Membrane Electrode Assembly for High-Performance Proton Exchange Membrane Fuel Cells

Stainless Steel Fiber Felt As Cathode Diffusion Backing and Current Collector for A Micro Direct Methanol Fuel Cell with Low Methanol Crossover

Membrane Electrode Assembly Based on Buckypaper with Gradient Distribution of Platinum, Proton Conductor and Electrode Porosity

Stainless Steel Fiber Felt As the Anode Diffusion Backing and Current Collector for Μ-Dmfc

Structural Optimization of PEMFC Membrane Electrode Assembly

Enhancing membrane electrode assembly performance by improving the porous structure and hydrophobicity of the cathode catalyst layer

Investigation of a New Method to Prepare Low Methanol and Water Crossover Membrane Electrode Assembly for Passive Direct Methanol Fuel Cells

Performance and Mass Transfer Characteristics of an Air-Breathing DMFC

A cost-effective and highly efficient dissymmetric membrane electrode assembly designed for fuel cells