Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Implementation of Electrostatic Actuators for Suspended Test Mass Control

Electromechanical co-simulation analysis for contactless positioning and vibration isolation platform

Development of Vibratory Stress Relief Actuators Based on Giant Magnetostrictive Materials

Design and Research of a Linear Actuator for Electric Vehicle Active Suspension

Active Vibration Control of Flexible Structures with Super-Coiled Actuators

A Two-Stage Magnetically Enhanced Buoyancy Adjustment Actuator Based on Dielectric Elastomer

A Ground-Based Electrostatically Suspended Accelerometer

Experiments on Active Precision Isolation with A Smart Conical Adapter

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Self-Locking Avoidance and Stiffness Compensation of a Three-Axis Micromachined Electrostatically Suspended Accelerometer

A New Structure of Test Mass for Ground-used Electrostatically Suspended Accelerometer

Performance of a Sensitive Micromachined Accelerometer with an Electrostatically Suspended Proof Mass

System Integration and Control Design of a Maglev Platform for Space Vibration Isolation

Investigations of a Robotic Testbed with Viscoelastic Liquid Cooled Actuators

New LISA dynamics feedback control scheme: Common-mode isolation of test mass control and probes of test-mass acceleration

Active Low-frequency Vertical Vibration Isolation System for Precision Measurements

Decoupled 2-DOF Magnetic Levitation Actuator for Single-Body High-Throughput Pick-and-Place Module

A Sensitive Three-Axis Micromachined Accelerometer Based on an Electrostatically Suspended Proof Mass

Experiment Study of a Tri-Axis Electrostatically Suspended Micromachined Accelerometer

Identification and adjustment of the position and attitude for the electrostatic accelerometer's proof mass

A Novel Triple-Actuator Magnetic Suspension Balance System With Enhanced Load and Stability