Abstract:The heat transfer performance of a cryogenic heat pipe using N2-Ar binary mixture as working fluid is experimentally studied and discussed in this paper.Heat pipe is a high efficiency heat transfer device by utilizing the liquid-vapor latent heat of working fluid,but the disadvantage is that the operational temperature range of heat pipe is limited by the triple point and critical point of working fluid.While,wide operational temperature range is required in some cases,especially in the cryogenic field referring to the cooling down process from room temperature to ultra-low temperature.In order to study the heat transfer performance of the cryogenic heat pipe using mixture as working fluid,an experimental setup is established,in which the liquid nitrogen at atmospheric pressure and resistive heating wire wound around the evaporator act as the heat sink and heat source,respectively.The working fluid is charged into the cryogenic heat pipe by a safe and effective method,without high charging pressure and complex equipment.The filling ratio in the experiments is 1.0.The temperature distribution along the entire cryogenic heat pipe and the inner pressure are measured during the experiments.These parameters are recorded after the entire cryogenic heat pipe reaches a steady state under a certain heating power,and the heating power applied on the evaporator is increased step-wisely until the heat transfer limit of the cryogenic heat pipe,which is signified by the abrupt rise of the evaporator temperature.The heat transfer performances of the cryogenic heat pipe with pure-N2,pure-Ar and N2-Ar binary mixture working fluid are tested in the experiments,and the results of different working fluids are compared with each other.It is found that the cryogenic heat pipe with mixture working fluid has wider operational temperature range than that of the two pure working fluid cases,and the thermal resistance of the cryogenic heat pipe with mixture working fluid is lower than that of the pure-Ar case and higher than that of the pure-N2 case.The heat transfer limit of the cryogenic heat pipe with the mixture working fluid is the same as that of the pure-Ar case,e.g.160 W,higher than that of the pure-N2 case,e.g.110 W.

Heat transfer performance of cryogenic heat pipe with binary mixture working fluid

Heat transfer characteristics of thermosyphon with N2-Ar binary mixture working fluid

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Numerical investigation on cryogenic pulsating heat pipes with nitrogen

Natural circulation performance in a new cryogenic heat transfer unit

Experimental Study on the Thermo-Hydrodynamic Characteristics of a Nitrogen Pulsating Heat Pipe

Numerical Investigation on Pulsating Heat Pipes with Nitrogen or Hydrogen

Design And Performance Analysis Of Small Cryogenic Heat Pipes As Thermal Links For Cryocoolers

Experimental research on heat transfer performance of CO2 low temperature heat pipe

Research on Cryogenic Loop Heat Pipe Technology

Study on a Neon Cryogenic Oscillating Heat Pipe with Long Heat Transport Distance

Experimental Investigation of the Characteristics of Cryogenic Oscillating Heat Pipe

Heat Transfer Characteristics of a New Type of Copper Wire-Bonded Flat Heat Pipe Using Nanofluids

Experimental Investigation on the Performance of a Neon Cryogenic Oscillating Heat Pipe

Heat Transfer Limit Resulting from Heat Leak in a Cryogenic Loop Heat Pipe

Experimental Study on the Secondary Evaporator of a Cryogenic Loop Heat Pipe

Experimental study on temperature uniformity and heat transfer performance of nitrogen loop heat pipe with large area and multi-heat source

Recent Research and Development of Cryogenic Heat Pipes

Experiment of Heat Pipe Thermal Performance

Thermal Performance of an Axially Microgrooved Heat Pipe Using Carbon Nanotube Suspensions

Heat transfer performance on unequal-diameter pulsating heat pipe