Abstract:Permanent magnets (PMs) based on manganese show significant potential for applications in electric motors and devices as an alternative to Rare-earth PMs (REPMs). The metastable ferromagnetic τ phase of the Mn-Al system has magnetic performance between the REPM Nd-Fe-B magnets and the lower performance ferrite magnets. However, the maximum performance in Mn-Al PMs has not reached its theoretical limit, in part due to challenges in controlling crystalline defects such as anti-phase boundaries (APBs). APBs act as nucleation sites for domain reversal in Mn-Al and negatively affect magnetization by interrupting the L1 0 ordering, placing Mn atoms into AFM-coupled Mn-Mn configurations. In this study, Ab-initio modeling was used to screen ternary elements based on their affinity to segregate to the APB and on their preference for FM configuration. The ternary element addition of 1 at.% Ti lowered the density of APBs as observed in a transmission electron microscope. The 1 at. % Ti addition was observed to improve (BH) max over the base alloy, by preserving H ci and improving M r . It also significantly increased the fraction of twin boundaries in the τ phase. AFM behavior that was observed in the base alloy during T C heating experiments (Néel behavior) and high-field VSM measurements (spin-flop behavior) was effectively suppressed with the addition of Ti. Additionally, the Ti addition thermally stabilized H ci at 550°C, improving τ phase processability. Other candidate elements, Cr, V, and Zr, were modeled to have similar potential for minimizing APBs when added to Mn-Al.

Modulating Thickness Multipole Permanent-Magnets

Effect of Magnet Thickness on Electromagnetic Performance of High Speed Permanent Magnet Machines

Studies of the Performance of MMD- and MW-type Permanent Multipole Magnets

Studies on the performance of modulating thickness linear periodic magnets

DISCUSSIONS OF THE PERFORMANCE OF TWO TYPES OF PERMANENT MULTIPOLE MAGNETS

Analytical Modeling of Surface-Mounted PM Machines Accounting for Magnet Shaping and Varied Magnet Property Distribution

Analytical On-Load Subdomain Field Model of Permanent-Magnet Vernier Machines.

Analysis and Suppression of Cross-Coupling Demagnetization in Dual Permanent Magnet Machine for Direct-Drive Application

Magnet circuit design and optimization of giant magnetostrictive transducer

STUDIES OF THE FIELD DISTRIBUTION OF THE MODULATING WIDTH MULTIPOLE PERMANENT MAGNETS

A Nonlinear 3-D Hybrid Model for Surface-Mounted Permanent Magnet Machines Considering End Effect

Effect of permanent magnet's structure on static behavior of a superconducting thrust bearing

Comparison of Conformal Mapping Models in Permanent-Magnet Vernier Machines

MAGNETIC FIELD ANALYSIS OF PERMANENT MAGNET UNDULATOR

Experimental Determination Of The Magnetization Dependent Part Of The Demagnetizing Field In Hard Magnetic Materials

Enhance the Field Strength by Adding Soft Iron in the Hybrid Permanent magnet

Suppression of anti-phase boundary defects in Mn-Al-Ti permanent magnets

Analytical model and precise evaluation of multi-layer magnetic shielding performances considering ultra-weak magnetic properties

Anti-Demagnetization Capability Research of a Less-Rare-Earth Permanent-Magnet Synchronous Motor Based on the Modulation Principle

Influences of Magnet Arrangements on Air-Gap Field Modulation Effects in Interior Consequent-Pole PM Machines

Batch Fine Magnetic Pattern Transfer Method on Permanent Magnets Using Coercivity Change during Heating for Magnetic MEMS