Abstract:This article investigates the microstructure evolution, phase formation, and magnetic properties of Co2FeCr0.5Alx (x = 0.9, 1.2) complex component alloys, as a function of heat treatment temperatures (at 500, 600, 700, and 1150°C), using XRD, optical microscopy, electron microscopy and vibrating sample magnetometry (VSM). The alloy with 20.4 at% Al (x= 0.9), identified here as C1, consisted of microscale BCC1 phase and BCC nanoscale particles containing mainly Fe and Cr, and B2 matrix with mainly Al and Co. Partial transformation of the BCC1 phase to an FCC phase was observed at 700°C and full transformation at 1150°C, through twinning. For the sample with 25.5 at% Al (x= 1.2), identified as sample C2, there were only nanoscale BCC particles in the B2 matrix with the same element segregation between the phases as C1. This increase in Al (from x= 0.9 to 1.2) content stabilised the B2 matrix phase, reduced the grain size, and increased both saturation magnetisation (Ms) and coercivity (Hc). Moreover, increasing the heat treatment temperature resulted in an increase in grain size of the B2 matrix, volume fraction and average size of the micro BCC 1 and nanoscale BCC phases for both C1 and C2, which also modified the soft magnetic properties, with Ms and Hc increasing up to 600°C followed by a decrease until 1150°C. Using the structural information as inputs for density functional theory calculations of Hc and Ms, it has been found that the Hc is influenced by the grain size of the matrix, and the volume fraction and size of the BCC1 phase at temperature higher than 600°C for C1 and 700°C for C2, but is controlled by nanoscale BCC particles below these temperatures. The Ms is controlled by the elemental diffusion and segregation. Thus, the best combination of Hc and Ms was seen with antiferromagnetic Cr segregated and partitioning in the microscale BCC1 phase, and a B2 matrix with less Cr rich precipitation, formed at 500°C, where the misfit strain between B2 matrix and nanoscale BCC was low.

Evolution of Constitution, Structure, and Morphology in FeCo-Based Multicomponent Alloys

Effect of Co Addition on the Phase Structure and Magnetic Properties of Fe-Si-Al Alloys

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Microstructure evolution and metastable phase formation in undercooled Fe–30 at.% Co melt

Composition and phase structure dependence of magnetic properties for Co2FeCr0.5Alx (x=0.9, 1.2) multi principal component alloys

Effect of Mo on Phase Stability and Properties in FeMnNiCo High-Entropy Alloys

Design and microstructural development of a new eutectic Fe-Co-Ni-B multi-principal element alloy system

Comparison of the structure and properties of equiatomic and non-equiatomic multicomponent alloys

Microstructure Evolution and Grain Refinement Mechanism in Undercooled (cofe)50si50 Multi-Principal Element Intermetallics

Insight into the Microstructure and Micromechanical Behavior and Mechanism of the Constitutional Phase of FeNiCrAl0.63 Multi-Principal Element Alloy

FeCo-based multiphase composites with high strength and large plastic deformation

Cooperative regulation of mechanical properties and magnetoresistance effect in high-entropy alloys by spinodal decomposition

Crystallization behavior, soft magnetic properties and good bending ductility of high Fe content FeSiBCuPC alloys induced by composition design

Thermodynamic and Ab Initio Design of Multicomponent Alloys Based on (Fe50Mn30Co10Cr10)-xBx (x = 0, 5, 7, 10, and 15 at.%)

Composition Design Study of Strong and Ductile Mo-alloyed CoCrNi Medium-Entropy Alloys

Alloying effects and effective alloy design of high-Cr CoNi-based superalloys via a high-throughput experiments and machine learning framework

Exploring the Relationship between the Structural Characteristics and Mechanical Behavior of Multicomponent Fe-Containing Phases: Experimental Studies and First-Principles Calculations

Alloying behavior of W and Mo in the as-cast dual-phase FeNiCrAl multi-component alloys

Microstructures and mechanical properties of FeCoNi(MoW) high-entropy alloys

Achieving High Strength and Deformability in a High Entropy Alloy Containing the Multiscale Phase Structure

Metastable phase formation and microstructure evolution in undercooled Fe-30Co alloy