Abstract:In order to enhance the precision of target distance and intensity information in pulse laser 3D imaging system, the time-discriminating circuit and peak holding circuit were studied in detail. Based on analyzing the laser distance-detecting method and the selection of detector, the principle diagram of pulse laser 3D imaging system was given. In this system, pulse from laser was sent to transflective prism, and the reflected light triggered reference APD. Output signal from the reference APD was selected as starting signal for timing to enhance timing basic. Constant threshold discriminator and constant fraction discriminator were combined to form the timing discriminator. In this method, high precision of timing discriminator could be achieved while eliminating the effect of noise to the circuit. The transconductance circuit based on OPA861 was selected to hold the peak signal. The APD signal simulating system was constructed in laboratory, and performance of those circuits were tested. At l ast, testing result was given. Result shows that the precision of time discriminating circuit is better than 1 ns and the precision of peak holding circuit is better than 2.63% when the peak value of narrow pulse signal is less than 800 mV. The result can satisfy the requirement of latter experiment.

Design and Analysis of Pre-amplifier for Detection Circuit of Mechanically Dithered Ring Laser Gyroscope

Design of signal preamplifier circuit for fluorescence detection system in quantitative PCR instrument.

Analysis on Digital Automatic Gain Control of MEMS Gyro Driven-Loop Circuit

Theoretical and experimental investigation on signal detection system for laser gyroscope

Digital Detection and Optimization Design for Resonant Fiber Optic Gyroscope

Target-distance and intensity information detecting with high precision in laser imaging system

Research on Small Delay Signal Processor Method of Mechanical Dithered Ring Laser Gyro

Research on New Signal Processing Method of Mechanically Dithered Ring Laser Gyro

Detective method of the novel ring laser gyroscope

Detection Circuit Design for Weak Signals in Lidar Systems

Dither signal removal of ring laser gyro based on adaptive noise canceling

Design of Digital Lock-in Amplifier in Resonator Fiber Optic Gyro

Dither-Frequency-Track Method Based on Phase Sensitive Detector Technology in Mechanically Dithered Ring Laser Gyros

Digital Readout System for Micromachined Gyroscope and Analysis for Its Demodulation Algorithm

Application of AD7656 in signal detection system for differential ring lasers

Parametric Design for the Peak Amplitude of A Mechanical Dithering Ring Laser Gyroscope

Analysis of Short-term Lock-in Error Accumulation in Dither Ring Laser Gyroscope

The Signal Detection for the Levitated Rotor Micro Gyroscope

Design Method of Preamplifier Circuit with THS4012 in Laser Altimeter

Design of Pre-Amplifiers for Photoelectric Detector

Design and simulation of high-precision scanning amplifier