Abstract:Epitaxial compositionally graded (Ba 1-x Sr x )TiO 3 (BST) (0.0≤x≤0.25) thin films were deposited on (100) LaAlO 3 substrates by pulsed laser ablation, the substrates having bottom electrodes made of 100-nm-thick conductive La 0.5 Sr 0.5 CoO 3 (LSCO). Extensive X-ray diffraction, rocking-curve, and φ-scan studies indicate that the graded films are (100)-oriented and exhibit good in-plane relationships of [010] BST //[010] LAO and [001] BST //[001] LAO . For the up-graded films with barium concentration (1-x) increasing across the film thickness in the direction from the film/substrate interface to the film surface, the full width at half maximum of the BST film (200) rocking curve and the surface roughness, examined by atomic force microscopy, were larger than those of the down-graded films with barium concentration decreasing from the film/substrate interface to the film surface. The dielectric properties of the graded films, measured using vertical structures, show that at room temperature, the dielectric constant (ε r ) and dissipation factor (cosδ) at 100 kHz were 380 and 0.013 for the up-graded films, and 650 and 0.010 for the down-graded films, respectively. The dielectric behavior was enhanced in the down-graded films, which was attributed to the fact that the pure BaTiO 3 layer in the down-graded BST films not only serves as a bottom layer but also acts as an excellent seeding layer for enhancing subsequent film growth, leading to better film crystallinity and larger grain sizes in the down-graded films. The graded BST films undergo a diffuse phase transition, giving a broad, flat capacitance-versus-temperature profile. With such a graded structure, it is possible to build a dielectric thin-film capacitor having a capacitance which has a low temperature dependence over a broad temperature regime.

The Resistance Degradation of (ba0.5sr0.5)tio3 Thin Films

Leakage current of (Ba0.5Sr0.5)TiO3 thin film prepared by pulsed-laser deposition

Microstructures and Dielectric Properties of Compositionally Graded (ba 1-X Sr X ) TiO 3 Thin Films Prepared by Pulsed Laser Deposition

Dielectric Properties of (ba0.5sr0.5)tio3 Thin Films

Enhanced Piezoresponse and Dielectric Properties for Ba1-XSrXTiO3 Composition Ultrathin Films by the High-Throughput Method

Time Dependent Dc Resistance Degradation In Lead-Based Perovskites: 0.7 Pb(Mg1/3nb2/3)O-3-0.3 Pbtio3

Progressive Loss of Ferroelectricity under Bipolar Pulsed Fields and Experimental Determination of Non-Switchable Polarization in Au/Ba0.5Sr0.5-TiO3/SrRuO3 Thin-Film Capacitors

Effect of zinc and magnesium ion doping on leakage current behavior of Ba0.6Sr0.4TiO3 thin film

Dielectric Properties and Microstructures of Ba 1−x Sr X TiO 3 Epitaxial Thin Films with Compositional Gradients Normal to the Substrates

Ferroelectric Properties of (ba0.5sr0.5)tio3/pb(zr0.52ti0.48)o3/ (ba0.5sr0.5)tio3 Thin Films with Platinum Electrodes

Microstructure and dielectric properties of compositionally-graded (Ba1−xSrx)TiO3 thin films

Improving Energy Storage Properties in (ba0.75sr0.1bi0.1)(ti0.9zr0.1)o3 Ceramic Thick Films by Adding (sb0.5li0.5)tio3, Domain Engineering and Defect Engineering

Preparation of epitaxial compositionally graded (Ba 1-x Sr x )TiO 3 thin films with enhanced dielectric properties

Characteristics of BST Thin Film Prepared by Novel Chemical Solution Deposition Method for High-Density DRAM Application

BST Thin Film Deposited on Glass Substrate with TISI Nanowire Electrode by RF-Sputtering Method

Study on Compositionally Graded Epitaxial Barium Strontium Titanate Thin Films Derived from Pulsed Laser Deposition

The Properties of Multi-Layered Pt/(Ba0.5sr0.5)Tio3/Pb(Zr0.52ti0.48)O-3/(Ba0.5sr0.5)Tio3/Pt Capacitors

Frequency dependent negative capacitance of (Ba0.6Sr0.4)(ZrxTi1-x)O3 thin films grown on La0.9Sr1.1NiO4 buffered SrTiO3 substrate

Effect of internal interface layer on dielectric properties of doped Ba0.6Sr0.4TiO3thin films and its simulation in filters

Misfit Dislocation Core Structures At Ba0.5 Sr0.5TiO3 /LaAlO3 Interfaces

Structure and Ferroelectric Properties of Barium Titanate Films Synthesized by Sol–gel Method