Abstract:The micro-defects on KH2PO4 (KDP) optic surfaces are mainly repaired by the micro-milling technique, while it is very easy to introduce brittle cracks on repaired surfaces, as KDP is soft and brittle. To estimate machined surface morphologies, the conventional method is surface roughness, but it fails to distinguish ductile-regime machining from brittle-regime machining directly. To achieve this objective, it is of great significance to explore new evaluation methods to further characterize machined surface morphologies. In this study, the fractal dimension (FD) was introduced to characterize the surface morphologies of soft-brittle KDP crystals machined by micro bell-end milling. The 3D and 2D fractal dimensions of the machined surfaces and their typical cross-sectional contours have been calculated, respectively, based on Box-counting methods, and were further discussed comprehensively by combining the analysis of surface quality and textures. The 3D FD is identified to have a negative correlation with surface roughness (Sa and Sq), meaning the worse the surface quality the smaller the FD. The circumferential 2D FD could quantitively characterize the anisotropy of micro-milled surfaces, which could not be analyzed by surface roughness. Normally, there is obvious symmetry of 2D FD and anisotropy on the micro ball-end milled surfaces generated by ductile-regime machining. However, once the 2D FD is distributed asymmetrically and the anisotropy becomes weaker, the assessed surface contours would be occupied by brittle cracks and fractures, and corresponding machining processes will be in a brittle regime. This fractal analysis would facilitate the accurate and efficient evaluation of the repaired KDP optics by micro-milling.

Fractal and Wavelet Methods Used in the Feature Extraction of Machining Processing from 3D Machined KDP Surfaces

Analysis of 3D microtopography in machined KDP crystal surfaces based on fractal and wavelet methods

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Fractal Analysis on Machined Surface Morphologies of Soft-Brittle KDP Crystals Processed by Micro Ball-End Milling

Fractal Analysis on Topography of KDP Surfaces by Single Point Diamond Tools Method

Modification of Three Dimensional Topography of the Machined KDP Crystal Surface Using Wavelet Analysis Method

Morphological Analysis of KDP-Crystal Workpiece Surfaces Machined by Ultra-Precision Fly Cutting

Evaluation of the Wavelet Transform Method for Machined Surface Topography 2: Fractal Characteristic Analysis

Surface Morphology Analysis Using Fractal Theory in Micro Electrical Discharge Machining

Evaluation of the Wavelet Transform Method for Machined Surface Topography I: Methodology Validation

Complex Wavelet Enhanced Shape from Shading Transform for Estimating Surface Roughness of Milled Mechanical Components

Multi-Scale Topography Analysis of Multi-Axis Machined Surfaces Based on Dual-Tree Complex Wavelet Transform

Research into the Application of Fractal Geometry in Characterising Machined Surfaces

Hybrid Dimension Based Modeling of Part Surface Topography and Identification of Its Characteristic Parameters

Research on Fractal Dimension Calculation Method of Machining Surface Based on Wavelet Transform

Multi-scale Texture Filtering-Based Quantitative Machining Mechanism Characterisation for Ultra-Precision Machined Surfaces

Investigation on the Generation of the Medium-Frequency Waviness Error in Flycutting Based on 3D Surface Topography

Multiscale characterization and contact performance analysis of machining surfaces

Surface roughness evaluation and morphology reconstruction of electrical discharge machining by frequency spectral analysis

Fractal Dimension Characterization for Surface Microtopography of Copper Cut by Single Point Diamond Tool

FEATURE EXTRACTION AND ASSESSMENT USING WAVELET PACKETS FOR MONITORING OF MACHINING PROCESSES