Abstract:Load bearing conjunctions are never perfectly flat. They are covered by surface features, which may be either unintentional roughness inherent in the manufacturing process or a combination of such roughness with intentionally introduced surface texture. In either case, only a small proportion of load bearing surfaces are in contact and carry load. This depends on the surface topography, material properties and contacting conditions. Simple surface roughness characterisation parameters such as Ra, Rp etc. although commonly used do not give an adequate description, particularly where surfaces are deliberately textured. Furthermore Imaged surface topographies commonly exhibit features below the resolution of the imaging apparatus. We demonstrate the application of a fractal geometry analysis to honed internal combustion engine cylinder liners, imaged by Atomic Force Microscopy and Confocal Laser Scanning Microscopy. This method enables anisotropic surfaces to be characterised by five parameters which can then be used to generate model surfaces whose characteristics follow very closely those of the measured surface. Analysis of the structure function allows the determination of length scales and roughness features relevant at a given contact length. The reconstruction of anisotropic surfaces is demonstrated. Results from modelled contacts between these surfaces reveal the likely asperity contact geometry to be used in modelling contact and friction in these interfaces.

Research into the Application of Fractal Geometry in Characterising Machined Surfaces

Characterization of Engineering Ceramics Ground Surface Based on Fractal Theory

Fractal characterization of mechanical surfaces

Fractal theory and the application in mechanical junction surface

Fractal Characterization of Two Grinding Surfaces

Quantitative Analysis for Micro Geometrical Characteristic of Rough Surface Profile Based on Fractal Theory

Evaluation of the Wavelet Transform Method for Machined Surface Topography 2: Fractal Characteristic Analysis

Fractal Characterization of Nano Anisotropic Rough Surface

Evaluation of the Anisotropy of Machined 3D Surface Topography

Research On The Fractal Of Surface Topography Of Grinding

Fractal Interpolation of Machined Surface Profiles

Fractal Characterisation of Inhomogeneous Rough Surfaces

Fractal characteristics of 3D surface topography in laser machining

SIMULATION AND CHARACTERIZATION OF FRACTAL ROUGH SURFACES

The Fractal Characterization of Mechanical Surface Profile Based on Power Spectral Density and Monte-Carlo Method

Surface Morphology Analysis Using Fractal Theory in Micro Electrical Discharge Machining

Fractal Characterization and Simulation of Surface Microtopography Machined with Abrasive Jet Precision Finishing with Grinding Wheel As Restraint

3d Fractal Dimension Measurement Of Smooth Engineering Surfaces

A New Method for Calculating the Fractal Dimension of Surface Topography

Evaluation of the Wavelet Transform Method for Machined Surface Topography I: Methodology Validation

Study on Fractal Characteristic of Surface Micro-Topography of Micro-WEDM