Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. In this study, a novel TCU control structure and algorithms including also dynamic model of the transmission will perform the gear shifting of automatic transmissions used in tracked military vehicles are designed. In case of inherent wear of the clutches, the clutch parameters are estimated by means of an adaptation algorithm that uses only the information from the transmission input and output speed sensors. These estimated clutch parameters are used in clutch torque calculation is utilized by control algorithms. For the clutch speed control in the inertia phase, a PID control structure with a negative feedforward term that cancels the nonlinearities of the system is proposed. The feedforward term utilizes the estimated wear clutch coefficients in the calculation of friction coefficients. The parameters of the PID controller are optimized by a genetic algorithm. The designed all structure are firstly tested on a MATLAB/Simulink power train simulation model, and then tested using a unique transmission on a transmission dynamometer test bench to examine its suitability for real transmission scenarios. The performances of proposed PID control and a backstepping nonlinear controller that we constructed for the tracked vehicles are compared with and without clutch wear. Maximum tracking error is decreased by 98% with proposed adaptive PID control structure with nonlinear feedforward term compare to backstepping controller. In the case of clutch wear, the back-stepping control exists in the literature has been found to result in oscillation. By updating the estimated friction coefficient from adaptation algorithm, in the backstepping controller, it is concluded that these oscillations can be eliminated. Additionally, on-off solenoid valves, are widely used, are known to cause torque interruptions and jerks during gear shifting. It has been observed the control structure presented in this study reduced the jerks by one quarter.

A Control Strategy on Starting Up of Vehicle with Automatic Manual Transmissions (AMT)*

Compound Sliding Mode Motion Trajectory Tracking Control of an Electro-Pneumatic Clutch Actuator While Maximizing Its Stiffness

Study on the control law of automated mechanical transmission clutch

Engagement Control of Automated Clutch for Vehicle Launching Considering the Instantaneous Changes of Driver's Intention

Analysis and Modeling for Electro-pneumatic AMT System

Automatic Clutch Control Based on Estimation of Resistance Torque for AMT

A Study on Control Strategy under Tip-In Condition Based on Amt Vehicle

Multi-state control strategy of starting for a wet friction clutch via a fuzzy logic algorithm

Research on AMT System Starting Control Strategy

Shifting Control Strategy Research in the Hard Accelerating Condition Based on the AMT Vehicle

Integrated and Intelligent Shifting Control of Automated Mechanical Transmission

Wet Dual Clutch Launching Adaptive Control Considering Service Time

Simulation of AMT autoshift process based on matlab/simulink/stateflow

Shifting Control of Automatic Mechanical Transmissions for Electric Vehicles Based on Optimal Control Theory

Coordinated Clutch Slip Control for the Engine Start of Vehicles with P2-hybrid Automatic Transmissions

Position and Force Switching Control for Gear Engagement of Automated Manual Transmission Gear-Shift Process

Automatic Mechanical Transmission Control Research Based on Torque on Low Tire-road Friction Condition

Research on clutch position control based on backstepping method for small-sized tractors

Simulation Analysis of Tractor AMT Shifting Process Based on Fuzzy Optimization of Downshifting

Simulation Of Wet-Clutch Short-Time Load End Speed Control System On Amesim

Dynamic modeling, clutch parameter adaptation, and control of automatic transmission for tracked vehicles