Abstract:alpha-Alumina (alpha-Al2O3), widely used as a raw material or production in advanced manufacturing industry, has attracted much attention in terms of its preparation temperature. A simple dissolution-evaporation-precipitation process was employed to obtain the amorphous Al-oxalate (AAO) precursor, serving as the starting material for the low temperature preparation of nano alpha-Al2O3. The crystalline structure and thermal behavior of the AAO were compared with commercially available aluminum hydroxide (Al(OH)(3)) powder using the X-ray powder diffraction (XRD) instrument, the thermal gravity analysis and differential scanning calorimetry (TG-DSC). The phase transition mechanism of AAO was investigated by the fourier transform infrared spectroscopy (FTIR), transmission electron microscope (TEM), scanning electron microscope (SEM), and Al-27 magic angle spinning nuclear magnetic resonance (Al-27-MAS-NMR). The DSC results indicated that AAO underwent a phase transformation at 982 degrees C. The alpha-alumina diffraction peaks appeared in AAO at 1000 degrees C, while alpha-Al2O3 phase was observed for Al(OH)(3) at 1200 degrees C. Furthermore, an absorption peak at 452 cm(-1), corresponding to Al-O bond in alpha-alumina was detected at 1000 degrees C. The proposed low-temperature preparation mechanism of alpha-alumina from AAO is as follows: four coordination Al-oxalate species entities coexist within the AAO sample; with increasing temperature, organic acid functional groups oxidize and volatilize, resulting in the formation of tetra-coordinate [AlO4], penta-coordinate [AlO5], and hexa-coordinate [AlO6] atomic groups; these atomic clusters further polymerize to form a structurally dense alpha-alumina crystal at the nano-scale (similar to 50 nm) at around 1000 degrees C. The experimental findings present a novel approach and method for the low-temperature preparation of nano-sized alumina powder. Additionally, a feasible theoretical reference for the low-temperature phase transition mechanism of amorphous Al-oxalate was provided.

Study on the Morphology of Α-Al2o3 Precursor Prepared by Precipitation Method

Synthesis of NdAlO3 Fine Ceramic Powders Via Co-precipitation Process

Preparation of Ultrafine Α-Al2o3 Powders by Thermal Decomposition of AACH

Low Temperature Phase Transition Mechanism of Amorphous Al-oxalate to Nano Α-Alumina

Morphology Controllable Synthesis Of Gamma-Alumina Nanostructures Via An Ionic Liquid-Assisted Hydrothermal Route

Lowering the synthesis temperature of α‐Al2O3 by increasing the content of pentacoordinate aluminum in the precursors

Effect of composite additives on phase transition and dispersibility of α-Al2O3

Preparation of NiAl2O4/Al2O3 composite nanopowder

Preparation of α-Al2O3 by low-temperature calcining γ-Al2O3 with α-phase seed in-situ obtained by ball milling

Synthesis and sintering behavior of a nanocrystalline α-alumina powder

Effect of Precursor on Aggregation of AlOOH Nano-particles Prepared by Hydrothermal Process

Effects of Al2o3 Phase Composition on Alon Powder Synthesis Via Aluminothermic Reduction and Nitridation

Synthesis of plate-like α-Al2O3 single-crystal particles in NaCl–KCl flux using Al(OH)3 powders as starting materials

Preparation, sintering behavior and microstructure of Al2O3-Coated Ni powders

Homogeneous nucleation of corundum nanocrystallites by rapid heating of aluminum formate hydroxide-based precursor powder

A study on preparation of ultrafine powders of Ni(OH)2 and NiO with different shapes by precipitation transformation method

Fabrication and Characterization of Mono-Dispersed Al2O3 Powders

Investigation on the Preparation and Properties of Monodispersed Al2O3ZrO2 Nanopowder Via Co-precipitation Method

Synthesis of α-Al2O3 nanoparticles with uniform size distribution by stearic acid-assisted mechanochemical method

Synthesis of AlN nanocrystalline powders

Morphology Evolution in Hydrothermal Synthesis of Mesoporous Alumina