Abstract:New time-based readout (TBR) electronics has been developed and evaluated for its performance and application for PET detectors. It consists of a leading edge (LE) timing threshold for timing pickoff that provides a signal timing t1; a charge integration followed by a constant discharge between two specific timings t2 and t3 that are used to directly measure the signal energy. The timing-walk error caused by LE from signals of different amplitudes can be measured with t1 as a function of different signal amplitudes that is proportional to the time difference between t2 and t3. With this pre-calibration, timing-walk error can be accurately corrected. Therefore, both signal timing and energy can be accurately measured with digital timing signals without using CFD and ADC. These timing signals were controlled and in principle can be measured by an FPGA that can apply many signal logic and data correction algorithms. A single channel discrete component TBR circuit has been implemented in PC board, and 8-channel ASIC chips have been developed for feasibility evaluations and PET detector applications. Initial functionality and performance evaluations have been conducted. Signal amplitude measurement accuracy and linearity are very good; the measured timing accuracy from a pulse is the same as a standard CFD and reaches to similar to 100 ps resolution with the test setup. Both suitable energy and coincidence timing resolutions (similar to 17% and similar to 1.0-2.0 ns) were achieved with PMT or Solid-State PM (SSPM) array based PET detectors. Initial studies to acquire flood source crystal identification map has demonstrated the advantages of applying parallel readout with TBR electronics that read out and process signals from each pixel of SSPM array independently. With its relatively simple circuit and low cost, TBR electronics is expected to provide suitable front-end signal readout electronics for compact photon detectors such as SSPM array that require large number of output channels and demand high performance in energy and timing.

Timing Signal Benchmark Module Design for All-Digital PET System

Timing Optimization For Digital Pet Detector Module Based On Fpga-Only Mvt Digitizers

A Scalable Synchronized Timing System For Digital Pet

The design of a time-interleaved analog-digital conversion modulator based on FPGA-TDC for PET application

An FPGA-based 64-channel DAQ system using linear time-over-threshold scheme for a continuous crystal PET detector

Design and Implementation of High-Precision Timing Module for NR Terminals Based on FPGA

Energy And Timing Measurement Of A Pet Detector With Time-Based Readout Electronics

An Analog Front-end ASIC Design for 16-Channel SiPM Readout in PET Detectors

A Simple Smart Time-to-digital Convertor Based on Vernier Method for a High Resolution LYSO MicroPET

A Novel Nuclear Pulse Digitizing Scheme Using Time over Dynamic Threshold

Performance Evaluation of Time Distribution over SerDes-based Interconnections for PET System

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

Energy and Timing Measurement with Time-Based Detector Readout for PET Applications: Principle and Validation with Discrete Circuit Components.

An FPGA-Based Fast Linear Discharge Readout Scheme Enabling Simultaneous Time and Energy Measurements for TOF-PET Detectors

A Design of FPGA Based Small Animal PET Real Time Digital Signal Processing and Correction Logic

Initial Implementation of All-Digital PET DAQ System

Design and performance of a 16-channel coarse-fine TDC prototype ASIC

A New Solution of Time Synchronization in All-Digital Pet Based on Tdc

Analysis of digital timing methods with DRS4 module

A 56-ps multi-phase clock time-to-digital convertor based on Artix-7 FPGA

A Linear Time-Over-Threshold Digitizing Scheme and Its 64-Channel Daq Prototype Design on Fpga for A Continuous Crystal Pet Detector