Abstract:Fluorapatite/hydroxyapatite [Ca 10 (PO 4) 6(OH) 2-x F x, FHA] has similar bioactivity to hydroxyapatite with smaller solubility in human body. FHA films are suitable to be used as coat layer on metallic implants to create bioactivity. In this work, FHA films on Ti6Al4V substrates were prepared by sol-gel technique in Ca(NO 3) 2-P 2O 5-HPF 6-ethanol system. The liquid film was formed by a dip-coating; the as-dipped film was dried at 150℃ for 15 min and heated at 600℃ for 15 min for each run. For each film sample, the dip-coating procedure was repeated for 5 times. The prepared films were characterized by XRD and XPS for identifying the film phase composition and by a soaking test in citric acid modified phosphate buffer solution for measuring film dissolution. The results showed that HPF 6 was a good reagent for the incorporation of fluorine into apatite to form FHA films; the fluorine contents in the film could be controlled; the dissolution of the films decreased with an increase in fluorine content of the films and pH value of the soaking solution. The sol-gel derived FHA films showed a smaller difference in dissolution amount at pH～7, and a large difference at pH～6, compared with the hydroxyapatie film. This behavior demonstrates that the FHA films have good bioactivity besides good stability in body fluid. On the other hand, the FHA films had higher adhesion strength than hydroxyapatite film. This could be attributed to the smaller thermal expansion coefficient of FHA which leads to smaller thermal residues stress.

Thermophysical Properties and Bioavtivity Reaearch of FHA

Phase Structure and Thermal Stability of Prepared FHA Powders

Research on the Preparation and Bioactivity of FHA Coatings

Fluoridation of Synthetic Apatite: Effect on the Formation of Calcium-Deficient Hydroxyapatite and the Properties of Porous Scaffold

Effect of Fluorion on Fluor-Hydroxyapatite Nano-Powder

Synthesis and Characterization of Fluorine-Substituted Hydroxyapatite Powder by Polyacrylamide-Gel Method

Characterization, mechanical properties, corrosion behaviour and bone-like apatite formation ability of fluorine substituted hydroxyapatite coating

The F content in sol–gel derived FHA coatings: an XPS study

Sol-gel Derived Fluorapatite/Hydroxyapatite Films and Their Solubility

Sol–gel Preparation of Zn-doped Fluoridated Hydroxyapatite Films

Fluorine substituted hydroxyapatite microspheres: Template-free hydrothermal synthesis and sustained fluoride-releasing properties

Synthesis and Characterization of Fluoridated Hydroxyapatite with a Novel Fluorine-Containing Reagent

Microwave-Assisted Solid-State Synthesis of Fluorinated Hydroxyapatite

The Interfacial Study of Sol–gel-Derived Fluoridated Hydroxyapatite Coatings

[Wet Synthesis and Characterization of Fluoride-Substituted Hydroxyapatite].

Fluoridation and sintering of hydroxyapatite material and their mechanical properties

Synthesis of Boronized Ti6Al4V/FHA Composites by Microwave Sintering for Dental Applications

Integrity and Zeta Potential of Fluoridated Hydroxyapatite Nanothick Coatings for Biomedical Applications.

Preparation and Characterization of Fluorinated Porcine Hydroxyapatite.

Adhesion Strength of Sol–gel Derived Fluoridated Hydroxyapatite Coatings

Sol-gel Preparation of Fluoridated Hydroxyapatite in Ca(NO3)2-PO(OH)3−x(OEt)x-HPF6 System