Abstract:In the nuclear reactor design, the critical heat flux (CHF) is one of the most important parameters for the reactor safety analysis. The occurrence of CHF will cause a sharp increase in the fuel rod surface temperature, which will result in the failure of fuel claddings and damage of the core. The CHF depends on the local flow conditions and the geometry of the flow channels, which makes the prediction of CHF in a fuel assembly more difficult when considering the cross flow between neighboring channels, spacer grids and mixing vanes. In this paper, the departure from nucleate boiling (DNB) type CHF in rod bundles under motion conditions is investigated based on the coupled analysis of the subchannel method and a CHF mechanism model, namely the liquid sublayer dryout model. The liquid sublayer dryout model assumes that there is a thin liquid sublayer underneath a vapor blanket formed by the coalescence of small bubbles near the heated wall. The dryout of this sublayer is considered as the CHF occurrence. In the liquid sublayer dryout model, sublayer thickness, velocity and length of the vapor blanket are three crucial parameters. In present research, the subchannel code calculates the local flow conditions for the rod bundle and provides input parameters for the liquid sublayer dryout model to predict CHF. In order to verify the method above, the predicted results are compared with the CHF Look-Up Table 2006 (LUT-2006) and a reasonable agreement can be achieved. In addition, the effects of rod bundle inlet coolant mass flow rate, subcooling and motion conditions on the CHF are analyzed.

Flow Behavior Analysis in Tight Lattice Rod Bundle Using CFD Method

Steady-state Simulation of Core-Annulus Flow in a Circulating Fluidized Bed (CFB) Riser

CFD evaluation of turbulence models for flow simulation of the fuel rod bundle with a spacer assembly

Some characteristics of air-water two-phase flow in the subchannel of a tight lattice rod bundle

Prediction of Forced Gas Flows in Circular Tubes at High Heat Fluxes Accompanied by Laminarization

Study on Flow Field in an Elbow Draft Tube by 3D Numerical Simulation

Advanced CFD modeling of rod bundle channels with integrated porous media and momentum source schemes

Cfd Investigating the Effects of Different Mixing Vane Designs on the Localized Thermal-Hydraulic Characteristics in the Rod Bundles with Grid Spacer

Simulation of Flows Around Two Tandem Rotating Cylinders in a Channel Using LB-DF/FD Method

Lattice Boltzmann simulation of viscoelastic flow past a confined free rotating cylinder

The numerical investigation of the thermal–hydraulic behavior in a 3 × 3 rod bundle with spacer grids

Simulation of flow around two rotating cylinders in a side-by-side arrangement at long channel using LB-DF/FD method

Investigating flow and heat transfer characteristics in a fuel bundle with split-vane pair grids by CFD methodology

A Lattice Boltzmann Subgrid Model for Lid-Driven Cavity Flow

CFD investigating the flow characteristics in a triangular-pitch rod bundle using Reynolds stress turbulence model

Study on Laminar-Turbulent Transition in Square Arrayed Rod Bundles

Numerical Simulation and Experimental Study on Gas Flow in an Open Lattice Structure for an Advanced Space Nuclear Power System

Numerical Investigation of Two-Phase Flow Through Tube Bundles Based on the Lattice Boltzmann Method

Numerically simulating the thermal–hydraulic characteristics within the fuel rod bundle using CFD methodology

Numerical Computations on Flow and Heat Transfer Characteristics of a Helically Coiled Heat Exchanger Using Different Turbulence Models

Study on the Prediction of DNB-Type Critical Heat Flux in Rod Bundle Under Motion Conditions