Abstract:For signal processing of a Micro-Electro-Mechanical System (MEMS) Inertial Measurement Unit (IMU), a digital-analog hybrid system-on-chip (SoC) with small area and low power consumption was designed and implemented in this paper. To increase the flexibility of the processing circuit, the designed SoC integrates a low-power processor and supports three startup or debugging modes for different application scenarios. An application-specific computing module and communication interface are designed in the circuit to meet the requirements of IMU signal processing. The configurable clock allows users to dynamically balance computing speed and power consumption in their applications. The chip was taped out under SMIC 180 nm CMOS technology and tested for performance. The results show that the chip's maximum running frequency is 105 MHz. The total area is 33.94 mm2. The dynamic and static power consumption are 0.65 mW/MHz and 0.30 mW/MHz, respectively. When the system clock is 25 MHz, the dynamic and static power consumption of the chip is 76 mW and 66 mW, and the dynamic and static power consumption of the FPGA level are 634 mW and 520 mW. The results verify the superiority of the application specific integrated circuit (ASIC) solution in terms of integration and low power consumption.

Design and Implementation of 16-bit RISC MCU for Medical Electronics Applications

Logical Architecture Design of Integrated Electronic System with High Real-Time and Reliability in ZDPS-2 Pico-Satellite

Implementation of an Embedded Dual-Core Processor for Portable Medical Electronics Applications

Optimal Design of a Low-Power, Phase-Switching Modulator for Implantable Medical Applications.

A low-power remotely-programmable MCU for implantable medical devices

Design of a Media-Enhanced and Reconfigurable RISC ,Microprocessor

Design Of Portable Infrared Business Card Exchange System On Chip

Design of Low Power Consumption Controller Applied to Implantable Medical Device

Low-power SoC design and system implementation for medical applications

Signal Processing System-on-chip Design for Biomedical Applications.

Ultralow Power Processor Employing Block Instruction for ECG Applications

Design of low-power and high-speed multiplier

A Low Power MCU Design for Battery-Less TPMS SoC

Design of SPI Interface and Bootrom Program in PKU-DSPII

[MCU Selection Analysis in Portable Electronic Medical Instrument Design].

Towards ultra low-power MCU implementation through physical design based on improved multibit SRPG

An Energy-Efficient Soc For Closed-Loop Medical Monitoring And Intervention

Design and Implementation of an On-Chip Low-Power and High-Flexibility System for Data Acquisition and Processing of an Inertial Measurement Unit.

Embedded Micro-Controller Unit System for Mixed-Signal Processor

Design of Remote Interworking Intelligent Medicine Chest Based on MSP430 Microcontroller

Architecture Design of an Asynchronous Low Power Microcontroller and Its VLSI Implementation