Abstract:Based on the recently constructed n-body potential, both molecular dynamics and Monte Carlo simulations revealed that the Al-Zr amorphous alloy or metallic glass can be obtained within the composition range of 24–66 at. % Zr. The revealed composition range could be considered the intrinsic glass-forming range and it quantitatively indicates the glass-forming ability of the Al-Zr system. The underlying physics of the finding is that, within the composition range, the amorphous alloys are energetically favored to form. In addition, it is proposed that the energy difference between a solid solution and the amorphous phase could serve as the driving force of the crystalline to amorphous transition and the driving force should be sufficiently large for amorphization to take place. The minimum driving forces for fcc Al-based and hcp Zr-based Al-Zr solid solutions to amorphize are calculated to be about −0.05 and −0.03 eV/atom, respectively, whereas the maximum driving force is found to be −0.23 eV/atom at the alloy stoichiometry of Al60Zr40. A thermodynamics parameter γ¯, defined as the ratio of the driving force to the formation energy of the solid solution, is further proposed to indicate the glass-forming ability of an Al-Zr alloy. Thermodynamics calculations show that the glass-forming ability of the Al56Zr44 alloy is the largest, implying that the Al56Zr44 amorphous alloy is more ready to form than other alloys in the Al-Zr system. Besides, Voronoi analysis found that there exists a strong correlation between the coordinate number and structure. Amorphization could result in increase of coordinate numbers and about 1.5% volume-expansion. The volume-expansion induced by amorphization can be attributed to two factors, i.e., the total bond number of the Al-Zr amorphous phase is greater than that of the corresponding solid solution, and the averaged bond length of the Al-Zr amorphous phase is longer than that of the corresponding solid solution. For the Al-Zr alloys, especially for the Al-Zr amorphous phase, there exists a negative chemical micro-inhomogeneity in the alloys, suggesting that metallic bonds prefer to be formed between the atoms of dissimilar species. Finally, it is found that there is a weak correspondence between the bond-angle distributions of Al-Zr amorphous alloys and the solid solutions. It is further suggested that the configuration of Al-Zr amorphous alloys embodies some hybrid imprint of bcc, fcc, and hcp structures. More interestingly, the short-range order is also observed in the bond-angle distributions.

A first-principle study of the structural and electronic properties of amorphous Cu-Zr alloys

Stability of the Zr-based Amorphous Alloys Evaluated from the Electronic Structure of Their Basic Clusters

First-principles study on alloying stability, electronic structure, and mechanical properties of Al-based intermetallics

Calculation of electronic density of states for an amorphous Zr-Cu alloy

Amorphous alloys in Zr-Al-Ni-Cu system

Structural, Elastic and Electronic Properties of Cu-X Compounds from First-Principles Calculations

Structural Relationship Between Crystalline and Amorphous States in Cu-(Zr, Ti) Binary Systems

Theoretical study on the composition location of the best glass formers in Cu-Zr amorphous alloys

Influence of Zr Element on the Atomic Structure of Al-Cu Alloy Liquid

Structural, elastic and electronic properties of Mg(Cu1-xZn x)2 alloys calculated by first-principles

Experimental Investigation and Thermodynamic Description of the Cu-Zr System

Development of suitable interatomic potentials for simulation of liquid and amorphous Cu–Zr alloys

Glass-formation and atomic structures of Cux(Zr 0.22Hf0.78)1-x and (Cu0.61Hf 0.39)1-xZrx alloys investigated by Monte Carlo simulation

The Structural, Elastic, and Electronic Properties of Zr X Nb 1− X C Alloys from First Principle Calculations

Ab Initio Molecular Dynamics Simulation of Binary Cu64zr36 Bulk Metallic Glass: Validation of the Cluster-Plus-Glue-Atom Model

The structural stability, mechanical properties and stacking fault energy of Al3Zr precipitates in Al-Cu-Zr alloys: HRTEM observations and first-principles calculations

Consideration of cluster and state density of electrons during design of stable amorphous alloys

Structural, Elastic, and Electronic Properties of Al-Cu Intermetallics from First-Principles Calculations

Formation and structure of Al-Zr metallic glasses studied by Monte Carlo simulations

The icosahedral short-range order and its local structures in Cu50Zr40Al10 alloy

First-principles study of phase transformations in Cu–Cr alloys