Abstract:The highly reactive chemical nature of aluminum makes it production energy-intensive or essentially impossible to extract alloying elements from Al-based liquids. Using molten salt fluxing and electrolysis processes can effectively refine coarse Al scraps. However, the generation of toxic gases and hazardous dross during these processes can cause significant environmental protection challenges and result in notable social concerns. Therefore, the primary recycling of post-consumer Al in industries currently proceeds mainly in a cascade manner, which is not sustainable when considering the Al cycle trends in the coming decades. Herein, we develop a novel process to separate primary Al from the crystallizing liquid when a constant electromagnetic force (EMF) is applied. Using this technique, we successfully upgraded Al–7mass%Si (hereafter, unless specified otherwise) alloy to approximately Al–3.6%Si in directional solidification. The separation mechanism was discussed in terms of the electrical properties of the respective phases during solidification. Fluid flow simulation results were applied to elucidate the separation behavior in the alloy. The upper and lower limits to separate the crystallizing alloy into an Al-rich and Si-rich areas were determined when the controlling factors were clarified, which made it possible to scale up the present laboratory-based setup to an industrial level. Moreover, the energy consumption of the process was slightly higher than that required for remelting only. Using the EMF technique to separate the crystallizing alloy into Al-rich and Si-rich regions did not produce hazardous dross or toxic gases. This energy-saving and eco-friendly process can provide a breakthrough to overcome the "dead metal" crisis and thus realize sustainability by upgrading recycling of post-consumer hypoeutectic Al–Si casting alloys.

Horizontal Electrorefining of Al in Na3alf6-Lif Molten Salt

Recovery of aluminum from waste aluminum alloy by low-temperature molten salt electrolysis

Impurity Behavior in Aluminum Extraction by Low-Temperature Molten Salt Electrolysis

Study on preparation of aluminum fluoride from cryolite

Preparation of aluminum fluoride from carbon residue in aluminum electrolysis cell by roasting-leaching method

Upgrading recycling of Al–7 wt%Si alloys using electromagnetic force in directional solidification

In-situ Anodic Precipitation Process for Highly Efficient Separation of Aluminum Alloys

Electrodeposition of aluminum on rare earth alloy surface in room temperature molten salts

An Inverted Aluminum Electrolysis Cell Using a High Density Electrolyte and an Inert Anode - A Test of the Concept

Recycling of Aluminum from Fibre Metal Laminates

A Novel Method to Remove Iron Impurity from Aluminum

Refining aluminum process in ionic liquids

A novel electrochemical method for the removal of aluminum from ionic rare earth leachate

Performance Evaluation of Low-Temperature KF-NaF-AlF₃ Electrolytes for Aluminum Electrolysis Using Vertical Inert Cu-Ni-Fe Alloy Anodes

Electrochemical Reduction of Al(III) and Si(IV) in the NaF-AlF3-Al2O3-SiO2 Molten Salt System and Preparation of Homogeneous Al-Si Alloys by Molten Salt Electrolysis

Effects of Electroslag Refining on Removal of Iron Impurity and Alumina Inclusions from Aluminum

Separation of Aluminum from More Noble Elements in an Electrolysis Cell with Side-by-Side Geometry

Removal of Iron from Commercial Aluminum by Electroslag Refining

A new process of alumina suspension electrolysis

Low temperature aluminum electrolysis in NaF-AlF3-BaF2-CaF2 bath system

Pre-electrolysis of electrolyte for silicon electrorefining