Simulation of Fischer-Tropsch synthesis and analysis of off gas treatment
Lu Xuefeng,Sun Li,He Gaohong
DOI: https://doi.org/10.3969/j.issn.1001-4160.2012.01.009
2012-01-01
Abstract:Fischer-Tropsch(F-T) synthesis,which can transfer the non-fossil fuels to liquid fuels,is one of the principal coal to liquid oil technologies.The F-T process includes five parts:coal gasification,water gas shift,gas purification,liquids oil synthesis,and combined cycle power.Besides the liquid production can be generated in the process of liquid oil synthesis,off gas is also produced simultaneously.The off gas contains some CO,H_2,C1-C4 light alkanes,and a small amount of heavy alkanes.Therefore,the off gas can be burned off to produce power and steam which must satisfy the requirement of the process.In addition,its components,such as CO and H_2,can be recovered in order to increase the output of the product.In this paper,the whole process which includes the above five parts was simulated using Aspen Plus which is one of the chemical process simulation software,and then three methods of the process off gas treatment were analyzed.Firstly,the off gas was fully bumed off to satisfy the process power and steam requirement,the remains could be transported to the power grid and the steam pipe network.Secondly,off gas was recovered to increase the output of the products,and this process needed to burn coal to make up the gap in the utility.At last,the off gas was partially burned off,and some coal could be burned off to supply power and stream.Different percentages of the off gas recovery were set up in this case.When considering all the process system,process products,and the utility system,20%of the off gas recovery produces the maximum economic benefit,and the off gas fully recovery produces the minimum benefit.