Abstract:A simple and highly selective flow injection on-line pre-concentration and separation-flame atomic absorption spectrometric method was developed for routine analysis of trace amounts of lead in biological and environmental samples. The selective preconcentration of lead was achieved in a wide range of sample acidity (0.075 to > or = 3 mol L(-1)HNO3) on a microcolumn (145 microL) packed with a macrocycle immobilized on silica gel. The lead retained on the column was effectively eluted with an EDTA solution (0.03 mol L(-1), pH 10.5). Three kinds of potential interferences, i.e., preconcentration inferences from metal ions with an ionic radius similar to that of Pb(II) due to their competition for the cavity of the macrocyle, elution kinetic interferences from ions which form stable complexes with EDTA due to their competition for EDTA, and interferences in the atomizer from residual matrix, were evaluated and compared in view of the read-out mode of the analyte response (peak area vs peak height), column wash step (with vs without), column capacity (50 vs 145 microL), and column shape (conical vs cylindrical). The results showed that a combination of increase in column capacity, quantitation based on peak area, and use of dilute nitric acid for column wash before elution efficiently avoid the above-mentioned potential interferences. With the use of a 145 microL column the present system tolerated up to 0.1 g L(-1) Ba(II), 1 g L(-1) Sr(II), and at least 10 g L(-1) Fe(III), Cu(II), Ni(II), Zn(II), Cd(II), Al(III), K(I), Na(I), CaII), and Mg(II) in the sample digest. Further improvement of the interference tolerance can be achieved by increasing column capacity if more complicated samples need to be analyzed. At a sample loading rate of 3.9 mL min(-1) with 30-s preconcentration, an enrichment factor of 52, a detection limit (3s) of 5 micrograms L(-1) Pb in the digest and a sampling frequency of 63 h(-1) were obtained. The precision (RSD, n = 11) at the 200 micrograms L(-1) level was 1.9%. The enrichment factor and the detection limit can be further improved by increasing sample loading rate without degradation in the efficiency due to the favorable kinetics and low hydrodynamic impedance of the present system. The analytical results obtained by the proposed method for a number of biological and environmental standard reference materials were in good agreement with the certified and recommended values.

Column Solid-Phase Extraction with 2-Acetylmercaptophenyldiazoaminoazobenzene (AMPDAA) Impregnated Amberlite XAD-4 and Determination of Trace Heavy Metals in Natural Waters by Flame Atomic Absorption Spectrometry

8.2.2 A High Spatial Resolution MEA for Voltammetric Analysis of Trace Metals in Water Pollution Based on Partial Least Squares Regression

Full Automatic Monitor for In-Situ Measurements of Trace Heavy Metals in Aqueous Environment

Dispersive Liquid–Liquid Microextraction and Micro-Solid Phase Extraction for the Rapid Determination of Metals in Food and Environmental Waters

Simultaneous Measurements of Cr, Cd, Hg and Pb Species in Ng L-1 Levels by Interfacing High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry.

On-line separation and preconcentration of trace cadmium in environmental water samples by micro column filled with modified nanometer Si-HAP prior to FAAS determination

Determination of Cadmium, Lead and Copper in Water Samples by Flame Atomic-Absorption Spectrometry with Preconcentration by Flow-Injection On-Line Sorbent Extraction.

Simultaneous Enrichment of Inorganic and Organic Species of Lead and Mercury in Pg L−1 Levels by Solid Phase Extraction Online Combined with High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry

THE DETERMINATION OF TRACE AMOUNTS OF HEAVY-METALS IN WATERS BY A FLOW-INJECTION SYSTEM INCLUDING ION-EXCHANGE PRECONCENTRATION AND FLAME ATOMIC-ABSORPTION SPECTROMETRIC DETECTION

Application of modified nano-alumina as a solid phase extraction sorbent for the preconcentration of Cd and Pb in water and herbal samples prior to flame atomic absorption spectrometry determination

Development of an air-assisted liquid-liquid microextraction method based on a ternary solidified deep eutectic solvent in extraction and preconcentration of Cd(II) and Zn(II) ions

Separation, Preconcentration, and Determination of Lead, Cadmium, and Iron Using Cloud Point Extraction with Flame Atomic Absorption Spectrometry

Microextraction technique of nanoparticles and atomic absorption spectrometry for determination of cadmium and calcium in water samples

Quantification of ultra-trace organolead species in environmental water by inductively coupled plasma mass spectrometry with online solid-phase extraction and high performance liquid chromatographic separation

Investigation of Dispersive Solid-Phase Extraction Combined with Slurry Sampling Thermospray Flame Furnace Atomic Absorption Spectrometry for the Determination of Cadmium

Determination of Traces of Ni, Cu, and Zn in Wastewater and Alloy Samples by Flame-AAS after Ionic Liquid-Based Dispersive Liquid Phase Microextraction

A Chelating Resin of EDTA-Type Modified Cross-Linking Polystyrene to Preconcentrate Trace Metals for Seawater Detection

Preparation of a high pH-resistant AAPTS-silica coating and its application to capillary microextraction (CME) of Cu, Zn, Ni, Hg and Cd from biological samples followed by on-line ICP-MS detection

Analysis of Trace Heavy Metal in Solution Using Liquid Cathode Glow Discharge Spectroscopy

Preliminary Results on the Determination of Ultratrace Amounts of Cadmium in Tea Samples Using A Flow Injection On-Line Solid Phase Extraction Separation and Preconcentration Technique to Couple with A Sequential Injection Hydride Generation Atomic Fluorescence Spectrometry

Application of a macrocycle immobilized silica gel sorbent to flow injection on-line microcolumn preconcentration and separation coupled with flame atomic absorption spectrometry for interference-free determination of trace lead in biological and environmental samples