Abstract:The influence of copper loading on the surface species and catalytic properties of Fe–Cu–K–La/SiO 2 catalyst in the formation of oxygenated by-products during Fischer–Tropsch synthesis was investigated by temperature-programmed reduction (TPR), temperature-programmed desorption of CO and acetaldehyde (CO-, acetaldehyde-TPD), in situ diffuse reflectance FTIR and chemical trapping. The results showed that addition of copper improved the reducibility of catalysts, however, the adsorption features of catalysts changed significantly. Fe–Cu–K–La–SiO 2 with a composition of 1:0.28:0.05:0.05:0.17 (molar ratio, relative to iron) had highest selectivity for hydrocarbons and lowest selectivity for C 2 + oxygenates. Results of FTIR and chemical trapping indicated that extra copper would suppress CO adsorption as well as oxidation of adsorbed molecules. The stability of intermediates weakened simultaneously. Moreover, the quantitative estimates of the concentration of the surface species by acetaldehyde-TPD allowed the illustration of copper effect on the catalytic properties. Graphical Abstract FTIR spectra of adsorbed species formed from CO + H 2 interaction on Fe-K-La/SiO 2 catalyst with different copper loadings: (a) 0.08; (b) 0.18; (c) 0.28; (d) 0.31; (e) 0.48: (A) 553 K, 3.5 MPa; (B) spectra after switching to pure H 2 . In-situ reaction was investigated which confirmed the results obtained in previous characterization including CO hydrogenation reaction, temperature-programmed desorption of adsorbed CO and acetaldehyde (CO-, acetaldehyde-TPD), in situ diffuse reflectance FTIR of methanol and acetaldehyde adsorption and chemical trapping. It could be seen that extra copper caused no apparent changes toward hydrogen which pointed to an unfavorable mobility of products formed on the catalytic surface and could be associated with the reduced reactivity of adsorbed molecules and weakened stability of intermediates with high copper loadings.

POISONING OF IRON CATALYST BY COS IN SYNGAS FOR FISCHER-TROPSCH SYNTHESIS

Thermodynamics of Carbonyl Sulfide Poisoning on F-T Synthesis Catalyst

Poisoning of Cobalt Catalyst Used for Fischer–Tropsch Synthesis

Xps Study of Iron Catalysts for Fischer-Tropsch Synthesis

Inhibition of CO in Blast Furnace Flue Gas on Poisoning and Deactivation of a Ni/Activated Carbon Catalyst in COS Hydrolysis

FTIR STUDY ON OXYGEN POISONING BEHAVIOR OF COS HYDROLYSIS CATALYST

Deactivation Mechanism for COS Hydrolysis over TGH Catalyst - FT-IR Study of the Adsorption Behavior of COS, O2 and H2S

Rational Design of Poisoning-Resistant Catalyst Based on Γ-Al2o3 for Hydrolysis of Carbonyl Sulfide

HYDROGEN SULFIDE POISONING OF METHANOL SYNTHESIS Cu-BASED CATALYST∗(II’) POISONING OF COMMERCIAL CATALYST

Spectroscopic and Transient Kinetic Studies of Site Requirements in Iron-Catalyzed Fischer−Tropsch Synthesis

Research into the Kinetics of COS Elimination from Syngas at Moderate Temperatures

Mechanistic Insights into the Effect of Sulfur on the Selectivity of Cobalt-Catalyzed Fischer–Tropsch Synthesis: A DFT Study

Mechanism of Sulfur Poisoning to Ru-based Catalysts in Supercritical Water Gasification of Glycerol: from Experiment to Combined DFT and Kinetics Studies

Effect of sulfur poisoning on the performance and active sites of Cu/SSZ-13 catalyst

Effect of Co-Feeding Carbon Dioxide on Fischer–Tropsch Synthesis over an Iron–manganese Catalyst in a Spinning Basket Reactor

Influence of Copper Loading on the Surface Species and Catalytic Properties in the Formation of Oxygenated By-products During FTS Over FeCuKLa/SiO 2 Catalysts

Low-temperature hydrolysis of carbonyl sulfide in blast furnace gas using Al2O3-based catalysts with high oxidation resistance

Unraveling the sulfur poisoning mechanism of N-doping KAl2O3 catalyst in simultaneous hydrolysis of COS and CS2 via experimental and theoretical study

Holey carbon nanomeshes with atomically Cu–N4 active sites for efficient carbonyl sulfide catalytic hydrolysis

Catalytic hydrolysis of carbonyl sulfide in blast furnace gas over Sm-Ce-Ox@ZrO2 catalyst

COS and H2S simultaneous removal from blast furnace gas over a tailored Cu/Zr co-doped K@TiO2 bifunctional catalyst under low temperature