Abstract:Field test results show that about 15% to 40% of building heat loss in China is attributable to poor heating systems regulation. The current method for addressing this problem is to install thermostatic radiator valves (TRVs) to the ends of radiators, a method adapted from northern Europe. However, this method has resulted in poor performance from delayed controlling action due to thermal inertia as well as insufficient system control accuracy. This is further compounded by incorrect operation by system users and a lack of financial incentives to regulate the system if users are not billed for their heat consumption. We present a new method for simultaneously heat controlling and metering. The core challenge is to design a control strategy that will maintain the room’s temperature. Thus, we established dynamic heat transfer models for water flow, the radiator and the building so as to obtain the optimal heating strategy. We also simulated the indoor thermal dynamic performance of the heating system with different heating loads, supply water temperatures, and supply water flow rates using three methods: a continuously changing flow rate (Method 1), a step-change flow rate based on temperature deviation (Method 2) and an intelligent step-change flow rate (Method 3) which predicts the duty cycle of the valve in the proceeding period and controls the valve’s on-time. The simulation results indicate the performance of these three methods. For Method 1, as the room temperature is above the set point, the flow rate can be automatically reduced to a level which is proportional to the room temperature deviation. Further, the scale factor of the flow rate is designed according to the +2°C deviation, so it is accepted that the room temperature is higher than the set point by +2°C using this method. However, this low control precision is unsatisfactory. The mean temperature is higher than the set point and greatly affected by the heating load and supply water’s temperature and flow rate. For Method 2, the controlling action is delayed by thermal inertia, the room temperature fluctuates between the highest and lowest levels, and the temperature deviation can be greater than the set value. For Method 3, both the simulation and field test results showed that room temperature deviation was maintained within a ±0.5°C range under the various conditions. This method appears relatively robust and adaptable, and was the best control strategy of the three methods.

Dynamic simulation of space heating systems with radiators controlled by TRVs in buildings

Simulation on Hydraulic Heating System of Building under the Control of Thermostat Radiator Valves

Simulation and Analysis on Control Effectiveness of TRVs in District Heating Systems

A novel on-off TRV adjustment model and simulation of its thermal dynamic performance

Simulation and Analysis of Building Dynamic Performance in Heat Metering Systems

Simulation Research on Low Temperature Hot Water Floor Radiant Heating System with Air Source Heat Pump

Dynamic Characteristics Simulation of Variable Temperature Heating Room

SIMULATION ON INDOOR THERMAL DYNAMIC PERFORMANCE OF HEATING SYSTEM UNDER THE ON-OFF VALVE ADJUSTING MODEL

Dynamic Process Simulation of Indoor Temperature Distribution in Radiant-Convective Heating Terminals

Dynamic modeling and intelligent heating strategies of district heating system based on the standardized thermal resistance

Dynamic Simulation and Control of Hydraulic Cases for Central Heating and Air-Conditioning System

Dynamic Temperature Model of District Heating System Based on Operation Data

Computer modeling and experimental validation of a building-integrated photovoltaic and water heating system

A Thermo-Hydraulic couplings model for residential heating system based on Demand-side Regulation: Development and calibration

MODELING AND SIMULATION OF UNDERFLOOR ELECTRIC HEATING SYSTEM WITH LATENT THERMAL STORAGE AND AIR SUPPLY

Analysis on Control Mechanism and Response Characteristics of Residential Thermostats in District Heating Systems

NUMERICAL SIMULATION IN A LARGE SPACE WITH CONVECTIVE HEATING RADIATOR

Steam Heating Network Simulation

Dynamic modeling of HVAC system with state-space method

Numerical Simulation on Heating Performances of a Radiant-Convective Heating Terminal

Analysis of dynamic model of heating system after step change of water supply temperature