Abstract:The synchronization process takes up almost one half of the time of the gear-shifting process, and also influences the impacts between the sleeve and the gear ring. To avoid impacts and reduce time duration, a time-optimal control strategy with angle alignment is necessary for the synchronization process. Moreover, to be better accord with practice, the motor torque response process should be taken into account. The parameters in the torque response process depend on control commands, which makes the control problem a multistage one. To solve these issues, a rule-based control strategy is extracted from the dynamic programming (DP) solution of the multistage time-optimal control problem. To obtain this strategy, the dynamic model for the synchronization process with a modified Sigmoid model to precisely depict the torque response process is first solved. Then, the control problem is formulated as a multistage time-optimal control problem with three states and solved by DP. Based on the DP results, a three-stage and a four-stage rule-based control strategies are extracted for normal operation situation and startup situation, respectively. Finally, through comparative studies, the proposed rule-based control strategy can eliminate the speed difference and angle difference simultaneously with almost the same time of the bang-bang control, while the bang-bang control cannot obtain the zero terminals. Moreover, the proposed control strategy only takes 20 ms more than the pure speed synchronization control in the worst case. It would decrease when the initial speed difference increases.

Coordinated Nonlinear Speed Control Approach for SI Engine with Alternator

Coordinated Nonlinear Speed Control Approach for SI Engine with Alternator Dynamic Performance Can Be Improved, for Vehicles with Spark-Ignition (SI) Engines and Alternators That Handle Heavy Electrical Loads, by Control Design Methods That Consider Both the Engine and the Alternator.

Speed Sensorless Nonlinear Control Of Pmsm Drives

Nonlinear control approaches for SI engine model with uncertainties

Engine Control Design Using Globally Linearizing Control and Sliding Mode

Nonlinear Speed Sensorless Control Of Pmsm Drives

Adaptive and Learning Control for SI Engine Model With Uncertainties

Nonlinear observer-based torque control for SI engine

Nonlinear Torque Estimation for Vehicular Electrical Machines and Its Application in Engine Speed Control.

A Full-Speed Sensorless Control Algorithm For Interior Permanent Magnet Synchronous Motor Using Sliding-Mode Observer And Hf Signal Injection

An Economic Nonlinear Model Predictive Control Strategy for SI Engines: Model-Based Design and Real-Time Experimental Validation

Adaptive Speed Control Based On Disturbance Compensation For Engine-Dynamometer System

Sensorless Speed Control for SPMSM Using a Nonlinear Observer and Enhanced Super-Twisting ADRC

Nonlinear Speed Control for PMSM System Using Sliding-Mode Control and Disturbance Compensation Techniques

Model based moving horizon optimization control of automotive engine speed

An Enhanced Nonlinear ADRC Speed Control Method for Electric Propulsion System: Modeling, Analysis, and Validation

Nonlinear Speed Control for Five-Phase PMSM in Electric Vehicles

Design of an SI Engine Cold Start Controller based on Dynamic Coupling Analysis

Nonlinear torque and air-to-fuel ratio control of spark ignition engines using neuro-sliding mode techniques

Multistage Time-Optimal Control for Synchronization Process in Electric-Driven Mechanical Transmission with Angle Alignment Considering Torque Response Process

Non-Cascaded Sensorless Control of SPMSM Based on Cascaded Extended State Observer