Abstract:ObjectivesThis paper aims to study the influencing factors and mechanisms of ship model resistance prediction uncertainty, as well as proposing corresponding suppression methods. MethodsResistance tests and local flow measurements on the flow around KCS models of 1.725 m and 3.450 m are carried out in a circulating water channel. The effects of the model scale on the resistance predictions are obtained by comparing the results of the two tests. Numerical simulations of the flow around the 3.450 m model in an unbounded water area and circulating water channel are achieved. The results under the two conditions are compared to analyze the blockage effect and validate the simplified Tamura correction formula. Numerical simulations of the flow around the 3.450 m model under different turbulence intensities in a circulating water channel are then carried out to analyze the effects of turbulence intensities on resistance predictions. ResultsThe results show that the resistance prediction uncertainty of small ship models due to statistics collections and inflow uniformity can be amplified if the inflow velocity is too low. This demonstrates that the blockage effect of the large model could increase hull sinkage, pressure gradients on the hull and wave amplitudes, leading to an increase in ship resistance. The average difference between the resistances predicted in the unbounded water area and circulating water channel is 4.56% without correcting for the blockage effect. The difference is reduced to 2.25% with the correction of the simplified Tamura formula. The total resistance increases by an average of 3.75% as the turbulence intensity increases from 1% to 2%. It is observed that the decay of turbulence intensity along the flow direction is linear from the entrance to the bow. ConclusionsThis study shows that reasonably large models should be used wherever possible and the turbulence intensity should be strictly controlled to reduce the uncertainty of ship resistance tests in circulating water channels. In addition, the simplified Tamura formula should be used to correct the blockage effect, and the appropriate inflow turbulence intensity should be used in numerical prediction according to the dissipation of the turbulence intensity.

Discussion of Mesh Generation Method for Ship Resistance Calculation

Research on Mesh Generation Effecting Resistance Calculation

Investigation on Some Factors Effecting Ship Resistance Calculation with CFD Code FLUENT

A method for ship resistance prediction based on CFD computation

Discussion of Grid Generation for Catamaran Resistance Calculation

Research on Factors of a Flow Field Affecting Catamaran Resistance Calculation

Discussion about FLUENT Software by the Numerical Calculation of Several Types of Vessels' Resistance

A Numerical Study on the Resistance Prediction of a Medium Speed Craft

Uncertainty suppression methods for CFD/EFD resistance prediction of ship model

Study on resistance prediction of fishery ship

Study on Resistance Performance of Working Ship with Notches Based on CFD

Preliminary Numerical Investigation of Effect of Interceptor on Ship Resistance

Study of Resistance Performance of Vessels with Notches by Experimental and Computational Fluid Dynamics Calculation Methods

A Numerical Calculation of Resistance of an Inland Large Self-propulsion Cutter Suction Dredger in Shallow Water

Hydrodynamic Performance Optimization of Ship Hull's Forebody

Analysis and comparison of the prediction of the added resistance for ships in regular waves based on theoretical and empirical methods

A review of the numerical strategies for solving ship hydroelasticity based on CFD-FEM technology

Full-scale CFD simulations for the determination of ship resistance as a rational, alternative method to towing tank experiments

An Investigation into Added Resistance of Vessels Advancing in Waves

Research of Resistance Estimation Method for High-Speed Catamaran

A Computational Fluid Dynamics Method for Resistance Prediction of the Floating Hull of Wave Glider