Abstract:The effect of preparation conditions such as sintering temperature on the luminescence properties of SrTiO_3∶Pr~(3+) phosphors doped by compensation ions with various valences were studied to obtain best luminescence property. The doping ions with various valences were selected to verify the charge compensation effect on the luminescence intensity as K and Al seem to have similar charge compensation effect. PL spectra were measured to analyze the effect of preparation parameters, such as doping ions of K, Ca, Al and sintering (temperature,) on the luminescence properties of SrTiO_3∶Pr~(3+) phosphors. And XRD measurements were carried out to verify the crystal structure of prepared SrTiO_3∶Pr~(3+) phosphors. The results revealed that all samples emit red light at 610 nm originating from ~1D_2→~3H_4 transition of Pr~(3+) (ions.) The luminescence intensity varies with sintering temperature, while the samples sintered at 1 150 ℃ have the best luminescence intensity. Among K, Ca and Al doped samples, only the Al-doped samples have the (obvious) enhanced luminescence intensity, the strongest luminescence intensity was about 10 times as that of pure SrTiO_3∶Pr~(3+) phosphor without compensation doping. On the other hand, phosphor doped with K ions, which likely has similar charge compensation effect as that doped with Al ions, has little effect on the improvement of luminescence intensity. Contrary, it has similar intensity as that of either pure SrTiO_3∶Pr~(3+) phosphors or Ca-doped phosphors which are believed to have not such charge compensation effect. Above result about the effect of various ions doping on luminescence properties could be explained by combination of charge compensation effect and substitution structure effect. The charge compensation effect is effective only when the doping ions Al~(3+) is substitute for the Ti ions which is the nearest neighbor ion to the (luminescence) ions of Pr~+_(Sr). Present study shows an optimal preparation condition and proposes a method to choose effective charge compensation ion for SrTiO_3∶Pr~(3+) phosphors with best luminescence intensity.

The effect of calcium concentration on the photoluminescence of CaTiO3: Pr3+ films prepared by the sol–gel method

Effect of Ca Deficiencies on the Photoluminescence of CaTiO3:Pr3+

Luminescent Properties of Pr3+ Doped (ca, Zn) TiO3: Powders and Films

Effect of Sr2+ substitution for equivalent Ca2+ ions on luminescence intensity of CaTiO3 : 0.002Pr(3+)

Enhanced Photoluminescence of CaTiO3:Pr3+ Phosphor Films Deposited on SiO2 Buffered Si Substrates

Effect of Compensation Ions and Sintering Temperature on the Luminescence Properties of SrTiO_3∶0.002Pr~(3+) Phosphor

Enhancement of Luminescent Properties of Sol-Gel-Derived BaTiO3: Pr

Synthesis of Ce3+and Pr3+-Codoped SrTiO3 and Its Luminescence Properties by Sol-Gel Route

Luminescent Properties of ZnxCa1–xTiO3:yPr3+ Long-Lasting Phosphors

Synthesis and Red Luminescence of Pr3+-doped CaTiO3 Nanophosphor from Polymer Precursor

(Zn, Ca) solid-solution behavior and its effect on luminescence properties in Ca1-xZnxTiO3 : 0.002Pr(3+) phosphors

Effect Of Oxygen Vacancies On The Red Emission Of Srtio3:Pr3+ Phosphor Films

Improved electrical properties of Pr-doped SrTiO3 films

(Zn,Ca) Solid-Solution Behavior and Luminescence Properties of Ca_(1-x)Zn_xTiO_3∶0.002Pr~(3+) Phosphors

Photoluminescence and its Enhancement of Pr<sup>3+</sup>-Doped BaTiO<sub>3</sub> Phosphor

Effects of Preparation Parameters on Microstructure and Properties of Calcium Titanate Oxides Thin Film

Luminescence and photocatalytic performance of Ca1−xTiO3:Pr3+ material

Effects Of Eu-Doping Site On Structural And Photoluminescent Properties Of Catio3 Particles

Synthesis of Zn0.2Ca0.8TIO3:0.1Pr3+ by sol-gel and its luminescence characterization

Enhanced Luminescence for Srtio3 : Pr3+ Phosphors with the Addition of Al3+ Ions

Luminescence Characteristics Of Ba0.5sr0.5tio3:Pr-X, Al-Y Powders Synthesized By Citrate-Nitride Combustion Process