Abstract:CAN-bus is a typical bus control technology, and is now widely applied in many areas.In view of the characteristics of the electric vehicle body, this paper puts forward a plan that applies CAN-bus technology to build electric vehicle body network. In terms of the electric vehicle body system, it needs to resolve several issues: One is to simplify electronic wiring harness as far as possible, and the other is to ensure the normal data communications. In this article, the body electrical is divided into different nodes in accordance with the principles of proximity, each node controls a certain area of electrical equipment, and at the same time, communicates with other nodes through CAN bus. CAN bus used SAE1939 agreement and defined message through this agreement. Each body node of the circuit includes main circuit board and extended board. The main circuit can achieve the requirements of data communications; the extended board can achieve the expansion of body electrical. The circuits are divided into several modules in application with circuit modular design approach. Every module was respectively developed by embedded software system through some software development tools, at the same time, tested the entire body CAN network communications systems. After the test, the entire body of communications network can meet the requirements.

Development of CAN Based on Electrical Controller Unit Bootloader Solution

Research and Development of ECU Programming Device for Electronic-Controlled Diesel Engine

Design and Application of CAN/LIN Gateway Controller in Automotive Body Network

The design of electric motor car's body network based on CAN-bus distributed control

Development of EOL Solution for High-pressure Common Rail Diesel Engine

Design of Boot Loader with Multiple Communication Port

Automatic Measurement and Control System for Vehicle ECU Based on CAN Bus

Development of a New Calibration System for Electronic Control Units Based on CCP

Design of Upper Computer System of High-End Loom Machine Controller Based on AT9261 and CAN Bus

Design and Analysis of Multi-Node CAN Bus for Diesel Hybrid Electric Vehicle

The Design of the Embedded Bus Controller Based on the Network Monitor System

Design of Hardware Circuit of Vehicle Control Unit and CAN Bus Communication for Hybrid Electric Vehicle

Design of Communication System Based on Controller Area Network for EV Battery Management System

The Design of AMT communication module based on CAN bus

Research and development of device for downloading and updating software of product ECU based on extended CCP

Development of Fault Diagnosis Interface for Diesel Engine Based on ISO 15765

Design and implementation of multi-channel CAN communication interface based on embedded Linux

The Control of Electric Vehicles Based on CAN Network

Technical Application of Controller Area Network on Hybrid Electrical Vehicle

Development of CAN Communication Card Driver Based On uClinux

Development of Engine Control Unit Monitoring and Calibration System Based on CCP