Abstract:In this article the "titanium oxide/electrolyte solution" interface is studied by taking in advantage the recent developments in the field of Surface and Interface Chemistry relevant to this oxide. Ab-initio calculations were performed in the frame of the DFT theory for estimating the charge of the titanium and oxygen atoms exposed on the anatase (1 0 1), (1 0 0), (0 0 1), (1 0 3)(f) and rutile (1 1 0) crystal faces. These orientations have smaller surface energy with respect to other ones and thus it is more probable to be the real terminations of the anatase and rutile nanocrystallites in the titania polycrystalline powders. Potentiometric titrations for obtaining "fine structured" titration curves as well as microelectrophoresis and streaming potential measurements have been performed. On the basis of ab-initio calculations, and taking into account the relative contribution of each crystal face to the whole surface of the nanocrystals involved in the titania aggregates of a suspension, the three most probable surface ionization models have been derived. These models and the Music model are then tested in conjunction with the "Stern-Gouy-Chapman" and "Basic Stern" electrostatic models. The finally selected surface ionization model (model A) in combination with each one of the two electrostatic models describes very well the protonation/deprotonation behavior of titania. The description is also very good if this model is combined with the Three Plane (TP) model. The application of the "A/(TP)" model allowed mapping the surface (hydr)oxo-groups [TiO(H) and Ti(2)O(H)] of titania exposed in aqueous solutions. At pH>pzc almost all terminal oxygens [TiO] are non-protonated whereas even at low pH values the non-protonated terminal oxygens predominate. The acid-base behavior of the bridging oxygens [Ti(2)O] is different. Thus, even at pH=10 the greater portion of them is protonated. The application of the "A/TP" model in conjunction with potentiometric titrations, microelectrophoresis and streaming potential experiments allowed mapping the "titania/electrolyte solution" interface. It was found that the first (second) charged plane is located on the oxygen atoms of the first (second) water overlayer at a distance of 1.7 (3.4) A from the surface. The region between the surface and the second plane is the compact layer. The region between the second plane and the shear plane is the stagnant diffuse part of the interface, with an ionic strength dependent width, ranging from 20 (0.01 M) up to 4 A (0.3 M). The region between the shear plane and the bulk solution is the mobile diffuse part, with an ionic strength dependent width, ranging from 10 (0.01 M) up to 2 A (0.3 M). At I>0.017 M the mean concentration of the counter ions is higher in the stagnant than in the mobile part of the diffuse layer. For a given I, removal of pH from pzc brings about an increase of the mean concentration in the interfacial region and a displacement of the counter ions from the mobile to the stagnant part of the diffuse layer. The mean concentration of the counter ions in the compact layer is generally lower than the corresponding ones in the stagnant and mobile diffuse layers. The mobility of the counter ions in the stagnant layer decreases as pH draws away from pzc or ionic strength increases.

FTIR internal reflection spectroscopy studies of the effect of pH on adsorption of oleate/oleic acid at the surface of a TiO2 thin film deposited on a Ge single crystal

Oleate Adsorption at an Apatite Surface Studied by Ex-Situ FTIR Internal Reflection Spectroscopy

Reaction of tetrabutyl titanate in the adsorption layer on Si02 surface

Influence of Iron Dopant on Crystallization and Photo-Induced Hydrophilicity of TiO2 Thin Films

Studies of Ethylene Oxide Adsorption on Pt−Sn Alloys with TPD, HREELS, UPS, and DFT Calculations

Adsorption of polyacrylic acid at oxide/water interfaces

Experiments on adsorption at hydrous metal oxide surfaces using attenuated total reflection infrared spectroscopy (ATRIRS) (IUPAC Technical Report)

In situ Fourier transform infrared-attenuated total reflection spectroscopy and modeling investigation of protein adsorption: Case of expanded bovine serum albumin on titanium dioxide anatase

New insight into surface adsorption thermodynamic, kinetic properties and adsorption mechanisms of sodium oleate on ilmenite and titanaugite

pH control on preparation of nano-TiO_2 by gel-sol process

Study on the Surface-Modification of Tio2 Nanoparticles

Adsorption of polyacrylic acid on titanium dioxide

ATR-FTIR Investigation on the Complexation of Myo-Inositol Hexaphosphate with Aluminum Hydroxide

Phosphate uptake by TiO2: batch studies and NMR spectroscopic evidence for multisite adsorption.

The effect of surfactant-free TiO2 surface hydroxyl groups on physicochemical, optical and self-cleaning properties of developed coatings on polycarbonate

Specific and High-Affinity Adsorption of Volatile Organic Compounds on Titanium Dioxide Surface

Binding of Formic Acid on Anatase TiO2(101)

Anisotropic Adsorption of 2-Phenylethyl Alcohol on a Rutile (110) Surface

IR-analysis of H-bonded H2O on the pure TiO2 surface

Mapping the surface (hydr)oxo-groups of titanium oxide and its interface with an aqueous solution: the state of the art and a new approach

Effect of pH on the Water/alpha-Al2O3 (1(1)over-bar-02) Interface Structure Studied by Sum-Frequency Vibrational Spectroscopy