Abstract:Thermal control of electronic components is a continuously emerging problem as power loads keep increasing. To solve these thermal problems impinging jets are generally used in engineering, science and industry for its good heat transfer performance. In this study; cooling of a flat plate under constant heat flux condition, inside a rectangular channel, consisting of one open and three blocked sides was experimentally and numerically investigated using a single air jet flow. The impingement surface was a copper plate of the same width as the jet nozzle. Inlet flow velocities were measured using a Laser Doppler Anemometer (LDA) system. Temperature measurements were performed using thermocouples. Local and mean Nu numbers were determined as a function of two parameters, (a) Jet-to-plate distance (H/Dh) in the range of 4–10 and (b) Reynolds number based on the hydraulic diameter of the slot nozzle in the range of 4000–10,000 (corresponding to an exit jet velocity from 6.5 to 16.2 m/s). Numerical investigation was also performed. Low Re number k–ε turbulence model was used during investigations. The results are presented in the form of graphs showing the variation of the local Nusselt number as a function of these parameters. The effect of Re number on local Nu number was examined for q″ = 1000 W/m2 and H/Dh = 6. In general, it was observed that heat transfer is sensitive to the Reynolds number and increases with increasing Re number. Average Nusselt number increases of 49.5 % from Re = 4000 to Re = 10000. Effect of H/Dh on heat transfer under impinging air jets was examined with local Nusselt numbers. Local Nusselt number was less sensitive to H/Dh in the range of H/Dh = 4–10. Average Nusselt number decreases of 17.9 % from H/Dh = 4 to H/Dh = 10. The highest average Nu number was achieved for Re = 10,000 and H/Dh = 4. The numerical results agreed well with the experimental data, including local and average Nusselt numbers. Correlations are proposed to predict the local Nusselt number as a function of Re number and H/Dh.

Experimental Investigation of Mixed Convection in A Rectangular Duct with A Heated Plate in the Middle of Cross Section

Experimental Study on Forced Convection Hydraulic and Thermal Characteristics in a Dimpled Flat Duct

LAMINAR FLOW AND HEAT TRANSFER IN THE DEVELOPING REGION OF HELICAL SQUARE DUCTS

Heat transfer and thermal–hydraulic evaluations of cross-circular grooved rectangular flow ducts depending on rectangular baffle design parameters

Experimental and numerical study of mixed convection heat transfer in a vented cavity partially filled with a porous medium: Effects of reynolds and rayleigh numbers on Nusselt number and flow regimes

Experimental and Numerical Investigation of Convection Heat Transfer in a Rectangular Channel with Angled Ribs

Thermal and flow dynamics of an inclined air heat exchanger equipped with spring turbulators in the transition flow regime

Transient Natural Convective Heat Transfer of A Low-Prandtl-Number Fluid from A Heated Horizontal Circular Cylinder to Its Coaxial Triangular Enclosure

Experimental study on single-phase heat transfer performance of internal helically finned tubes covering low Reynolds number in turbulent flow

Influence of corrugated jet plates on internal heat transfer and flow dynamics of double-wall cooling: experimental-numerical approach

Experimental and numerical study of heat transfer from a heated flat plate in a rectangular channel with an impinging air jet

Experimental study on natural convection from vertical cylinders with perforated plate fins

Turbulent flow and heat transfer in discrete double inclined ribs tube

Numerical investigation of laminar natural convective heat transfer from a horizontal triangular cylinder to its concentric cylindrical enclosure

An experimental study of the flow and heat transfer between enhanced heat transfer plates for PHEs

An Experimental Study of Natural Convection from an Array of Vertical Parallel Plates.

A Comprehensive Review of Mixed Convective Heat Transfer in Tubes and Ducts: Effects of Prandtl Number, Geometry, and Orientation

Experimental study of the influence of buoyancy on turbulent mixed convection in lead–bismuth eutectic flow under inclination conditions

Experimental Study on Convective Heat Transfer in Alternating Elliptical Axis Tubes

Experimental Investigation of nanofluid heat transfer in a square cross-sectional duct

Forced Convective Heat Transfer in a Porous Plate Channel